772330

ATAG WS90292PM Manual

45
Zoom out
Zoom in
Previous page
1/52
Next page
EN 9
MAINTENANCE
Saturation of the odor filters
After 120 operating hours, the exhaust setting and ‘C/F’ flash
alternately on the display. The grease filters must be cleaned.
Removing the odor filters
1. Remove the grease filters.
2. Push the mounting clip on the holder, tilt the holder down and
remove it from the motor housing.
Cleaning the odor filters
• Clean the odor filters every 3 months or when the display indicates
this. After up to 2 years (or if the filtres are damaged), the filters will
need to be replaced.
• The regenerable active odor filters can be washed by hand or in
the dishwasher at a maximum temperature of 65 °C. The washing
cycle must be done without other dishes and without dishwasher
detergent. Do not use any cleaning agents!
• Remove excess water. Be careful to avoid damaging the filter.
• Remove the odor filters from the holders.
• Place the filters in the oven to dry for at least 60 minutes at a
maximum temperature of 80 °C.
• After drying, put the odor filters back into the holders.
It is important that the odor filters are properly dried before
replacing them.
Reset the memory after replacing the odor filters. Switch on the
extractor hood and touch and hold the minus (-) key for 3 seconds
until “E” shows on the display. The extractor hood switches off.
Lighting
Replace the lighting
• The cooker hood is fitted with LED lighting.
• LED lamps guarantee you optimum lighting, a service life of up to
10 times longer than conventional lamps and energy savings of as
much as 90%.
Contact the technical department when LED lighting needs to be
replaced.
… 45 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG WS90292PM at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG WS90292PM in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2.13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info