GB 7
maintenance
cleaning
duct and hood
For cleaning the stainless steel parts and the glass plate, you
can best use a mild cleaning agent (washing-up liquid) and a
damp cloth. Dry with kitchen paper or a dry cloth.
The stainless steel regains its shine if you occasionally use a
stainless-steel care product or polish. The polish applies a
dirt-resistant layer to the stainless steel. Always clean the
stainless steel in the direction of polishing.
Atag supplies cleaning and care products for extractor hoods.
Never use abrasive cleaning agents (such as Vim, green
scourers or other scouring pads) or polishing cleaning agents
(such as liquid abrasives). Never use caustic agents. These
can attack the stainless steel.
grease filters
Clean the grease filters at least once a month.
removing
1 Switch the fan and lighting off.
2 Push the filter backwards using the indentation and pull
the front downwards.
3 Remove the filter from the hood.
cleaning
You can clean the filters in the dishwasher. Let the filters
drain well (through the slits at the side) before putting them
back.
removing grease
filters
GB 6
operation
switching on
introduction
You can set the extraction capacity and brightness on the
control panel. On this page you can read how to make use of
the facilities.
switching the fan on
Turn the fan knob to setting 1, 2, 3 or 4.
On setting 1, the fan runs slowly; on setting 4, the fan runs
quickly.
switching the fan off
Turn the fan knob back to the fan symbol.
The fan has been switched off.
switching the lighting on
Turn the lighting knob clockwise.
Keep turning the knob until the brightness required has been
reached.
switching the lighting off
Turn the lighting knob back to the lighting symbol.
The lighting has gone out.
fan knob
fan switched off
lighting knob
lighting switched off