129980
32
Zoom out
Zoom in
Previous page
1/38
Next page
740-1180
A
98
The drawing shows the building-in
dimensions of the extractor hood.
The adjustable section at the top end of the
chimney allows you to set the correct
height.
Take into account the maximum
tolerances.
Drill holes in the wall.
Attach the brackets to the wall using the
four screws and plugs provided.
Remove the filters.
Place the hood in its correct location.
Adjust the position of the hood with the
4 adjusting screws on the support brackets
Fix the two additional screws in the holes
above the brackets.
6
7
8
9
10
11
12
Mark out the position for the section using
the towers.
Fix the section (A) to the ceiling and/or wall
using the four screws and plugs supplied
(see next).
Fit the exhaust duct.
Slide the slide-out part of the towers in the
lowest part. Position the chimney in the
hood.
Fix the towers to the sides of the section
with the two screws supplied.
Remove the film from the edges of the
filters and replace the filters in the extractor
hood.
Hand over the instructions for use to your
customer.
installationbuilding-in dimensions
installation
1
2
3
4
5
42 ?
55 ?
275 ?
ø8 ?
580-955
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG wk 4 h at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG wk 4 h in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info