52538
7
Zoom out
Zoom in
Previous page
1/24
Next page
11 12
GB
Anti-grease filters
*Push the filters firmly to the rear (see fig. 3).
Allow to fall at the front to remove them.
*The anti-grease filters can be cleaned by
hand with neutral detergent. If the filters
are cleaned in a dishwasher, some
discolouration may occur. The
discolouration of the filters is not covered
by the guarantee.
Changing the light bulbs
Remove the cover ring by turning it a quarter
of a turn (1, see fig. 4). Remove the halogen
bulb by pulling it down carefully (2). Insert a
new halogen bulb (20 W) and replace the
cover ring.
Installation
Before assembling the appliance it is
necessary to remove the anti-grease filters.
The following procedures must be carried out
before installing the appliance:
*A proper wiring system must be installed.
*If your appliance is to be installed in
Discharging mode, the ventilation hole must
first be made and a proper pipe obtained to
connect the vent to the flange of the
extractor hood.
*When frying take special care to prevent
oils and fats from catching fire. Oil which
has already been used is especially
dangerous in this respect. Do not use
exposed electric grills.
Extraction system
The cooker hood must be connected in the
Discharge mode (fig. 2) cooking vapours
and/or odours are immediately discharged
outside (via the ceiling and/or a wall) by a
discharge duct using the hole positioned on
the top of the appliance.
Maintenance
The thorough cleaning and servicing of the
appliance ensures correct and long-lasting
operation:
*Use lukewarm water and a neutral liquid
detergent to clean varnished appliances.
Never use abrasive cleaning materials or
products (Vim, steel wool, green scouring
pads, liquid scouring agents).
*Never use corrosive or abrasive products
when cleaning steel copper or brass
appliances. It is recommended that
specialized products be used in accordance
with the instructions issued by the
manufacturer.
GB
The following warning applies only in the
United Kingdom:
It is possible that the colours of the wires in
the mains cable of this appliance may not
correspond with the coloured markings
identifying the terminals in your plug. If this is
the case, proceed as follows:
*The blue wire must be connected to the
terminal which is marked with the letter N or
coloured black;
*The brown wire must be connected to the
terminal which is marked with the letter L or
coloured red;
*Neither wire is to be connected to the earth
terminal of a three-pin plug.
*When making the electrical connections
check that the voltage corresponds with
that indicated on the rating plate inside the
extractor hood.
*In the event that your appliance is not fitted
with a non-separating flexible cable and has
no plug, or has no other device to ensure
omnipolar disconnection from the electrical
main with a contact opening of at least
3 mm, such a separating device must be
included in the fixed installation to ensure
disconnection from the main.
*Always disconnect this appliance from the
main before cleaning or servicing the
appliance.
*Never flambée under an extractor hood.
Safety instructions
*The distance between the hob and the lower
part of the extractor hood must be at
least 65 cm.
*Under no circumstances should the outlet
be connected to a duct which is also being
used to discharge exhaust gas from
appliances fuelled by an energy source
other than electricity (central heating
systems, thermosiphons, water
heaters, etc.).
*When installing the discharge outlet always
comply with the regulations in force as
issued by the relevant authorities.
*Caution is needed if an extractor hood and
another heat source (e.g. gas, oil, coal
stoves, etc.) which also requires air are
being used together in the same room, since
it is possible that the extractor hood may
deplete the necessary combustion air and
thus create a depression in the room.
In order to ensure that the exhaust gas from
the heat source is not drawn into the room,
the maximum depression permitted in the
room is 0.04 mbar. There must also be an air
source in the room which constantly feeds
the room with a steady flow of fresh air.
*To avoid possible risk of fire always comply
with the instructions for use when cleaning
anti-grease filters and when removing
grease deposits from the appliance.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG W6.0 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG W6.0 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 0,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info