634494
18
Zoom out
Zoom in
Previous page
1/32
Next page
Troubleshooting
ActionType of faultDisplay
Call the service division.Overfilling
See "Water remains in the dishwasher" in the table
below.
Water outlet fault
Check that the water tap is on.Water inlet fault
Turn off the water tap and call the service division.Inlet valve leakage
Turn off the machine with the On/Left-on mode button and then turn it on again to clear the error message from the display.
ActionPossible causesProblem
Remove the arms and clean them.The spray arms do not rotate.The dishes are not clean.
Check that the dishes are not blocking the
spray arms.
Avoid large packages.Old detergent. Detergent is a perishable
product.
Dose according to water hardness. Far too
much or far too little detergent results in
poorer dishwashing results.
Incorrect detergent dosage.
Select a higher temperature or a more
powerful programme.
Dishwashing programme too weak.
Do not cover porcelain with large bowls or
the like. Avoid placing very tall glasses in the
corners of the baskets.
Dishes loaded incorrectly.
Place dishes to sit steady.Glasses and cups have toppled over during
the programme.
Screw the filter firmly into place. See the
section Care and cleaning.
The filter is not correctly fitted.
Check that the salt compartment lid is
properly tightened. Otherwise call the service
division.
The water softener is leaking salt.Spots or films on the dishes.
See the section Settings.Incorrect water softener setting.
See the sections Before washing for the first
time and Settings.
Incorrect rinse aid dosage setting.
Top up with salt. See the section Before
washing for the first time.
Salt compartment empty.
Inactivate the setting TAB (3-in-1/ All-in-one
detergent) and top up salt and rinse aid.
3-in-1/ All-in-one detergent is used and the
setting TAB (3-in-1/ All-in-one detergent) is
activated.
Wash crystal at a low temperature and with
a conservative amount of detergent. Contact
the detergent manufacturer.
Too high temperature and/or too much
detergent can cause etching on crystal.
Unfortunately, this cannot be repaired, only
prevented.
Reduce the amount. See the sections Before
washing for the first time and Settings. If you
have very soft water, you may want to dilute
the rinse aid 50:50 with water.
Rinse aid dosage setting too high.The dishes have a sticky white/blue film.
16
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG VA68211RT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG VA68211RT in the language / languages: English as an attachment in your email.

The manual is 4,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ATAG VA68211RT

ATAG VA68211RT Installation Guide - English, German - 2 pages

ATAG VA68211RT User Manual - German - 32 pages

ATAG VA68211RT Installation Guide - Dutch - 2 pages

ATAG VA68211RT User Manual - Dutch - 32 pages

ATAG VA68211RT Installation Guide - French - 2 pages

ATAG VA68211RT User Manual - French - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info