556998
22
Zoom out
Zoom in
Previous page
1/60
Next page
Using the detergent
20
30
M
A
X
1
2
3
4
+
-
A
B
C
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appliance
door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
Setting and starting a
programme
Setting mode
The appliance must be in setting mode to
accept some operations.
The appliance is in setting mode when after
the activation, all the programme indicators
come on and the display shows 2 horizon-
tal status bars.
If the control panel shows other conditions,
press and hold function buttons (B) and (C)
at the same time until the appliance is in
setting mode.
Starting a programme without delay
start
1. Open the water tap.
2. To set a programme, keep the appli-
ance door ajar.
3. Press the on/off button to activate the
appliance.
4. Make sure that the appliance is in set-
ting mode.
5. Press the button of the programme you
want to set:
The programme duration flashes in
the display.
The phase indicators of the set pro-
gramme come on.
6. Close the appliance door. The pro-
gramme starts.
Only the indicator of the phase in op-
eration stays on.
The display shows the programme
duration that decreases with steps of
1 minute.
Starting a programme with delay
start
1. Set the programme.
2. Press the delay button again and again
until the display shows the delay time
you want to set (from 1 to 24 hours).
The delay time flashes in the display.
3. Close the appliance door. The count-
down starts.
The display shows the countdown of
the delay start that decreases with
steps of 1 hours.
The phase indicators of the set pro-
gramme go off.
When the countdown is completed, the
programme starts.
The phase indicator in operation comes
on.
The display shows the programme dura-
tion.
You can set a programme and the de-
lay start also with the appliance door
closed. In this condition, you have only
3 seconds after each setting before the
appliance starts to operate.
Opening the door while the
appliance operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the delay start while the
countdown operates
Press and hold function buttons (B) and (C)
at the same time, until all the programme
indicators come on and the display shows
2 horizontal status bars.
22
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG VA6311SF at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG VA6311SF in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 4,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info