772228
52
Zoom out
Zoom in
Previous page
1/56
Next page
Problem and alarm code Possible cause and solution
The level of water inside the
appliance is too high.
The display shows iF1.
Switch the appliance off and on.
Make sure that the filters are clean.
Make sure that the outlet hose is installed at the right
height above the floor. Refer to the installation instruc‐
tions.
The appliance stops and
starts more times during op‐
eration.
It is normal. It provides optimal cleaning results and ener‐
gy savings.
The programme lasts too
long.
If the delay start option is set, cancel the delay setting or
wait for the end of the countdown.
Activating options can increase the programme duration.
The remaining time in the
display increases and skips
nearly to the end of the pro‐
gramme duration.
This is not a defect. The appliance is working correctly.
Small leak from the appli‐
ance door.
The appliance is not levelled. Loosen or tighten the adjust‐
able feet (if applicable).
The appliance door is not centred on the tub. Adjust the
rear foot (if applicable).
The appliance door is diffi‐
cult to close.
The appliance is not levelled. Loosen or tighten the adjust‐
able feet (if applicable).
Parts of the tableware are protruding from the baskets.
Rattling or knocking sounds
from the inside of the appli‐
ance.
The tableware is not properly arranged in the baskets. Re‐
fer to basket loading leaflet.
Make sure that the spray arms can rotate freely.
The appliance trips the cir‐
cuit-beaker.
The amperage is insufficient to supply simultaneously all
the appliances in use. Check the socket amperage and
the capacity of the meter or turn off one of the appliances
in use.
Internal electrical fault of the appliance. Contact an Au‐
thorised Service Centre.
Once you have checked the appliance,
deactivate and activate the appliance. If
the problem occurs again, contact an
Authorised Service Centre.
For alarm codes not described in the
table, contact an Authorised Service
Centre.
WARNING! We do not
recommend using the
appliance until the problem has
been completely fixed. Unplug
the appliance and do not plug it
in again until you are certain
that it operates correctly.
52
52


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG VA4110MT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG VA4110MT in the language / languages: English, Dutch as an attachment in your email.

The manual is 1.35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info