692636
10
Zoom out
Zoom in
Previous page
1/32
Next page
2
Close the door and the dishwasher
counts down 1 hour at a time and starts
after the selected delay.
If you want to cancel the Delayed start
option, open the door and press and hold
the main power switch until the display
turns off.
Starting the dishwasher
Close the door to start the dishwasher. If
the main power switch is on the
dishwasher will start automatically when
the door is closed.
TIME - Time remaining
Once you have chosen a programme and
options, the time the programme took
when last used is displayed.
Status light
The status light on the bottom part of the
dishwasher indicates that a programme
has started.
Flashing light
This indicates a fault. See further in the
section Troubleshooting.
Status light
Stopping or changing a programme
If you want to change programme after
starting the dishwasher, open the door
then press and hold the main power
switch until the display turns off. Add more
detergent if the lid of the detergent
dispenser has opened. Then press the
main power switch, choose a new
programme and close the door.
Do you want to add more dishes?
Open the door. The dishwasher stops
automatically. Add the dishes and close
the door. After a while, the dishwasher
continues the programme.
If the dishwasher is turned off due
to a power failure
If the dishwashing programme was not
finished, the interrupted programme
continues when power is restored.
NOTE!
During drying, the programme is
interrupted if the power is cut or the door
is open for more than 2 minutes.
How to get the best drying results
Fully load the dishwasher.
Angle dishes with hollows, such as
cups, so that the rinse water will run off.
This is also important for plastic items.
Top up with rinse aid or increase the
rinse aid dosage level.
Activate the Auto open option.
Allow the dishes to cool before
unloading the dishwasher.
Once the programme has finished
The end of the programme is indicated by
one short signal from the buzzer. The
chapter Settings describes how to change
this function.
Moreover, the end of the programme is
indicated by the status light turning off.
See Status light in the chapter Using the
dishwasher.
10
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG VA3013RT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG VA3013RT in the language / languages: English as an attachment in your email.

The manual is 2,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ATAG VA3013RT

ATAG VA3013RT User Manual - German - 32 pages

ATAG VA3013RT User Manual - Dutch - 24 pages

ATAG VA3013RT User Manual - French - 24 pages

ATAG VA3013RT Installation Guide - All languages - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info