475425
18
Zoom out
Zoom in
Previous page
1/30
Next page
GB
Raccordement
de
l'appareil
Familiarisation avec l'appareil
Notes
Guarantee
L'appareil doit bien reposer au sol et
être
obligatoirement
mis
a
niveau
a ('aide de ses
pieds réglables.
Se référer au gabarit d'installation.
Eau résiduelle
Raccorder le tuyau d'évacuation
sur le manchon d'évacuation
du siphon de la
conduite
d'évacuation
d'eau.
Pour cela utiliser les
pièces
jointes.
Eau propre
Raccordement selon la
Instructions de montage.
La pression
d'eau doit être
de 0,3 bar au minimum et
ne
doit
pas dépasser 10 bar.
Si elle est
superieure,
prévoir un
réducteur de pression.
Le debit
d'eau
doit
être
au moins de 10 litres par minute.
Un branchement
d'eau
froide est
recommandé.
Un branchement
d'eau
chaude
raccourcit la durée du programme.
L'eau chaude
ne
doit pas
dépasser 60 °C.
Le raccordement à un chauffe-eau sans
pression n'est pas valable.
Branchement electrique
Ne brancher l'appareil
que
sur une prise de
cr
rant
normalisée:
courant altematif 220-230 V.
La prise de courant doit
être
protégee
par un fusible de 16 A
et se trouver à proximité
du lave-vaisselle.
Avant la lecture, feuilleter les
derniéres pages avec
les illustrations.
Tableau de commande
Figure 0
1.
Démarreur de programme
2.
Position de depart
3.
Déroulement du programme
4.
Ouverture
de la porte
5.
Commutateur principal
(MARCHE/ARRET), sélecteur
de programme
6.
Vue
d'ensemble du programme
7.
Voyant
de
controle
Vue
intérieure de
Ia
machine
Figure 0
12.
Réservoir pour
liquide
de rincage
13.
Réservoir pour detergent
14.
Réservoir pour
sel
régénérant
15.
Bras d'aspersion inférieur
16.
Fixation du bras inférieur
17.
Roulettes de panier
18.
Doseur pour zones dedureté de I'eau
19.
Panier
à vaisselle supérieur
avec étagère et bras
d'aspersion supérieur
20.
Chauffage
21.
Filtres amovibles
The dishwasher has been
thoroughly tested at the factory.
A few small water spots may remain.
They will disappear with the first use.
2.
If your dishwasher is a especially designed
model for installation under a worktop
(built-in model), but will be used as
a free standing unit with a supplementary
worktop, it must be secured so as not
to tip over. It can be secured to the wall
or adjacent kitchen unit.
3.
Disconnecting appliance.
-
Pull out the plug.
-
Turn off water tap.
- Detach hoses from tap
and drainage pipe.
-
Unscrew mounting screws
under the work plate.
-
Dismount base plate, if present.
-
Pull appliance out,
so that the hoses drag behind.
4.
To transport appliance, ensure that it is
placed either in upward position of flat on
its back. If transported otherwise, any
residual water found in the appliance may
get to the control units and adversely
influence the functioning of the
programmes.
5.
For comparative purposes only.
Arrangement according to: DIN 44990
Capacity: 12 place-settings
Arrangement example: Fig. ,D and iJ
Comparative programme: Normal 65°
Amount of dish-washing cleanser used
in the test-study: 25 g.
6.
Interference suppression:
Interference suppression as established
by the 87/308/EWG regulations.
The guarantee period of ATAG appliances
commences on the date of purchase.
The guarantee refers to the appliances
purchased in the United Kingdom and the
Republic of Ireland.
The working parts guarantee covers the
supply of replacement parts showing defects
due to material construction or manufacturing
faults for 5 years and during the first
12 months labour is also covered.
Normal wear and tear, ageing, incorrect use or
accidental damage; glass, rubber or plastic
parts, consumable items such as bulbs and
filters and repairs which are carried out by
non-authorised Service Engineers, will not be
covered by the warranty.
The date of purchase must be proved, if
required, by providing a dated receipt.
This guarantee does not in any way affect
your statutory rights.
UK AND REPUBLIC OF IRELAND
ATAG (UK) Ltd.
Clevedon, Avon BS21 6XU
Tel: 02 72 - 87 06 06
Fax: 02 72 - 87 13 71
30
0 -7
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG VA 250 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG VA 250 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info