475427

ATAG S6N22A Manual

22
Zoom out
Zoom in
Previous page
1/30
Next page
Derangements
Le
voyant
de
controle
de mise sous tension
ne
s'allume pas
La machine
ne
se met pas en
marche
L'appareil s'arrête
au prélavage
L'eau n'est
pas évacuée
complètement
Le couvercle du
distributeur
ne ferme
pas
Le bras d'aspersion inférieur
tourne mal
Dépót blanchátre
sur la vaisselle
Pour remédier soi-même aux petits derangements
Trainées sur les verres
Après le séchage,
it
subsiste des gouttelettes
d'eau
sur la vaisselle
Bruit de vaisselle
pendant le lavage
Les résultats de lavage
ne
sont pas satisfaisants
Causes possibles
-
La manette droite est restée sur
la position ARRET (figure 0/5).
-
La fiche du cable de raccordement n'est pas bien
enfoncée
dans
la prise de courant.
-
Le disjoncteur de
('appa
rt
ement
a déclenché.
-
La manette gauche nest pas sur la position
de depart (figure 0/2).
-
La porte de l'appareil n'est pas bien termée.
-
Le robinet d'arrivée
d'eau
n'est pas ouvert.
-
Le filtre
dans
la
conduite
d'arrivée
d'eau
propre est obstrué.
-
Le tuyau d'évacuation
d'eau
fait un coude ou un pli.
-
Le filtre est obstrué
(controler le filtre figure ,))).
-
Le programme n'a pas été terminé.
-
Retirer le bras gicleur et le nettoyer.
Nettoyer également le support du bras gicleur.
- Trop peu de produit de rinGage
-
Pas de
sel
régénérant
dans
le reservoir
-
Le bouchon du reservoir pour le
sel
régénérant
n'a pas été revissé A fond.
- La
quantité
de
liquide
de rinGage est trop
impo
rt
ante.
- La
quantité
de
liquide
de rinGage est
insuffisante.
-
La vaisselle est mal rangée.
-
La manette de démarrage gauche a été mise au-dela
de la position de depart (figure 0/2).
-
Les produits de lavage et/ou de nnGage sont mal doses.
-
Manette gauche tournée
après le remplissage de detergent.
De
ce
fait le detergent est distribué trop tot.
-
La vaisselle est mal rangée ou les paniers
sont trop charges.
-
La rotation du bras d'aspersion était génée
par des pieces de vaisselle.
-
Le filtre
mixte
est obstrué (figure ,))).
-
Le micro-filtre est obstrué (figure .k!/)
(Si nécessaire, les enlever et les nettoyer. A la remise en
place, le micro-filtre doit s'enclencher de faGon
ne
tt
e).
-
Le
bord
du filtre
ne
repose pas uniformément
dans
l'évidement de la cuve.
-
Les gicleurs du bras d'aspersion sont bouchés.
-
L e programme a été choisi trop doux.
Water softening
In order to work correctly,
the dishwasher needs soft water.
So a water softener is built-in.
When correctly set,
it softens the water.
Setting the water softener
Before using, try the test strips provided
to find out the level of water hardness.
The test-strip is attached to the enclosed
Aqua-Test page.
Your local water board will tell you
what the water hardness in your area is.
The water hardness dial should then
be set as shown in Fig. 0.
Importante
Note!
Please make absolutely sure that the lid (flap)
on the salt container is closed properly.
Soap suds must not get into the salt container.
Never put detergent into the salt container, as
the water softener would be damaged and a
guarantee claim could not be made against
this damage.
Filling regenerating salt
container
Fig.
Use only regenerating salt
intended for household dishwashers!
Before using the dishwasher for the first
time, fill approximately one liter of water into
the regenerating salt container.
To fill container, remove lower basket.
Unscrew cap of salt container (Fig.
0/14),
and fill with regenerating salt.
Filling can be made easier by using a
pouring cup.
Then screw cap tightly back into place.
Dishwasher regenerating salt is suggested.
When using salt tablets, do not fill
the container to the top.
Table-salt, road-salt or any other salt
should not be used. These salts usually
contain insoluble elements, which in time
can damage the softener.
(Regenerating salt can be obtained in most
large supermarkets).
The reserve container holds about 2 kg.
of regenerating salt.
After the first wash cycle,
the salt container will be full of water.
So adding salt should always be done
immediately before starting
the dishwasher. This way,
any excess salt solution will be
immediately thinned and washed away.
Low salt indicator
Fig. 0/23
In a hard water area salt must be added
as soon as the flooter can no longer
be seen.
38
… 22 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG S6N22A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG S6N22A in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info