467217
7
Zoom out
Zoom in
Previous page
1/20
Next page
7
Operating instructions ATAG Q-Solar
When there is a heat demand on CH and the cy-
linder contains sufcient heat (heated by the sun)
the modulating 3-way valve will pass the CH-water
via the Solar-CH coil in the cylinder. Sensor T8 and
T9 will measure the temperature differerence and
together with the standard data from the CMS it
decides if heat may be retreived from the cylinder
or that the boiler has to be red.
DHW demand is alway priority and if the cylinder
contains insufcient heat from the solar absorber,
the boiler will be red.
When an outside sensor is connected to the boiler,
the boiler works weather dependantly. This means
that the boiler control measures the outside tem-
perature and ow temperature. With this data the
boiler calculates the optimal ow temperature for
the installation.
The efciency of the boiler is very high and the
radiation convection and standby losses very low.
The emission of noxious substances is far below
the xed standards so the boiler meets the requi-
rements of SEDBUK Class A.
When the boiler is connected to an ATAG BrainQ
information interchange takes place between the
boiler and the BrainQ. For more information re-
garding the ATAG BrianQ, please refer to the user
manual.
ATAG BrainQ
Example SEDBUK ClassA
Normally the pipes bet-
ween absorber and
cylinder are insulated.
However it needs your
attention that the pipes
during operation can be
extreemly hot (>120°C).
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG Q-Solar at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG Q-Solar in the language / languages: English as an attachment in your email.

The manual is 0,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ATAG Q-Solar

ATAG Q-Solar Installation Guide - German - 44 pages

ATAG Q-Solar User Manual - German - 16 pages

ATAG Q-Solar Manual - Dutch - 2 pages

ATAG Q-Solar Installation Guide - Dutch - 44 pages

ATAG Q-Solar User Manual - Dutch - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info