675593

ATAG KD80178BDN Manual

12
Zoom out
Zoom in
Previous page
1/32
Next page
q
The more R 600a refrigerant there is in the appliance, the
larger the room in which the appliance is standing needs to
be. In rooms that are too small, a flammable mix of gas and
air may be created if there is a leak. According to the EN 378
standard, every 11 g of R 600a refrigerant requires at least
1 m
3
space in the room for the appliance. The amount of
refrigerant in your appliance is on the type plate inside the
appliance.
q
If the appliance is installed in a very damp environment,
condensed water may form on the outside of the appliance.
Always make sure that there is good ventilation - both at air
inlet and outlet - at the site of installation.
u
Pull off red transport lock.
After installation:
u
Remove protective films, adhesive tapes and transport lock
parts etc.
Note
u
Clean the appliance (see Operating Instructions,
Chapter "Cleaning the appliance").
4 Appliance dimensions
Fig. 1
A
(mm)
B
(mm)
C
(mm)
D
(mm)
E
(mm)
KD80178BDN 559 544 1770 695 15
5 Recess dimensions
The appliance is built-in and therefore completely enclosed by
a kitchen unit. The kitchen unit concerned must be built exactly
to the prescribed dimensions and allow for sufficient ventilation,
both at air inlet and outlet, to ensure proper appliance opera-
tion.
Fig. 2
F
(mm
)
G
(mm
)
H (mm) J
(mm
)
K
(mm
)
L
(mm
)
KD80178BDN 1772
—
1788
560
—
570
min. 550,
recom-
mended:
560
min.
500
min.
40
max.
19
The specified energy consumption applies to a unit depth of
560 mm. The appliance will work properly at a unit depth of 550
mm, but at a slightly higher energy consumption.
u
Check the wall thickness of the adjoining cabinets: it must
be min. 16 mm.
u
Only install the appliance in robust, stable kitchen units.
Secure the units against tipping.
u
Align the kitchen unit using a spirit level and marking square
and if necessary compensate with shims.
u
Ensure that the floor and walls of the unit are at right angles
to one another.
6 Unit door
-
Two doors are required for this kitchen unit: the upper for the
refrigerator and the lower for the freezer compartment.
-
The doors must be minimum 16 mm and maximum 19 mm
thick.
-
When both doors are closed, the gap between the upper
and lower door must be at least 3 mm high.
-
The gap between unit doors must be at the same level as
the gap between the appliance doors.
Appliance dimensions
12 * Depending on model and options
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG KD80178BDN at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG KD80178BDN in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ATAG KD80178BDN

ATAG KD80178BDN User Manual - English, German - 36 pages

ATAG KD80178BDN Additional guide - Dutch - 1 pages

ATAG KD80178BDN User Manual - Dutch, French - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info