482663

ATAG KA2292D Manual

124
Zoom out
Zoom in
Previous page
1/164
Next page
4_ safety information
safety information
SEVERE WARNING SIGNS FOR TRANSPORTATION AND SITE
Ř When transporting and installing the appliance, care should be taken to ensure that no
parts of the refrigerating circuit are damaged.
- Refrigerant leaking from the pipe work could ignite or cause an eye injury. If a leak is
detected, avoid any naked flames or potential sources of ignition and air the room in
which the appliance is standing for several minutes.
Ř In order to avoid the creation of a flammable gas-air mixture if a leak in the refrigerating
circuit occurs, the size of the room in which the appliance may be sited depends on the
amount of refrigerant used.
Ř Never start up an appliance showing any signs of damage. If in doubt, consult your dealer.
The room where the refrigerator will be sited must be 1m³ in size for every 8g of R600a
refrigerant inside the appliance. The amount of refrigerant in your particular appliance is
shown on the identification plate inside the appliance.
SEVERE WARNING SIGNS FOR INSTALLATION
Ř
Do not install the refrigerator in a damp place or place where it may come in contact with water.
- Deteriorated insulation of electrical parts may cause an electric shock or fire.
Ř Do not place this refrigerator in direct sunlight or expose to the heat from stoves, room
heaters or other appliance.
Ř Do not plug several appliances into the same multiple power board.
The refrigerator should always be plugged into its own individual electrical which has a
voltage rating that matched the rating plate.
- This provides the best performance and also prevents overloading house wiring circuits,
which could cause a fire hazard from overheated wires.
Ř If the wall socket is loose, do not insert the power plug.
- There is a risk of electric shock of fire.
Ř Do not use a cord that shows cracks or abrasion damage along its length or at either end.
Ř Do not bend the power cord excessively or place heavy articles on it.
Ř Never unplug your refrigerator by pulling on the power cord. Always grip plug firmly and
pull straight out from the outlet.
- Damage to the cord may cause short-circuit, fire and/or electric shock.
Ř Do not use aerosols near the refrigerator.
- Aerosols used near the refrigerator may cause an explosion or fire.
Ř This refrigerator must be properly installed and located in accordance with the manual
before it is used.
Ř After unpacking, keep the packing materials out of reach of children.
- There is a risk of death from suffocation if children put them over their head.
Ř Connect the power plug in proper position with the cord hanging down.
- If you connect the power plug upside down, wire can get cut off and cause fire or
electric shock.
Ř Make sure that the power plug is not squashed or damaged by the back of the refrigerator.
Ř When moving the refrigerator, be careful not to roll over or damage the power cord.
- This constitutes a fire hazard.
Ř The appliance must be positioned so that the plug is accessible after installation.
Ř The refrigerator must be grounded.
WARNING
WARNING
… 124 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG KA2292D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG KA2292D in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 13,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info