349322
142
Zoom out
Zoom in
Previous page
1/164
Next page
Removing any residual matter inside the water supply line after installing
filter.
1. Turn ON the main water supply & turn OFF the valve to the
water supply line.
2. Run water through the dispenser until the water runs clear
(approx. 1L). This will clean the water supply system and remove
air from the lines.
3. Additional ushing may be required in some households.
4. Open the refrigerator door and make sure there are no water
leaks coming from the water filter.
A newly installed water lter cartridge may cause water to
briey spurt from the water dispenser. This is due to air getting
into the line. It should pose no problem to operation.
Check the amount of water supplied to the ice tray. (Optional)
1. Lift up the icemaker bucket and gently pull out of the freezer.
2. When you press the Test button for 3 seconds, the ice cube container is lled with water from the
water supply tap after ice tray is twisted. Check to make sure the amount of water is correct(see
the illustration below).
If the water level is too low, the ice cubes will be small. This is a water pressure problem from
with in the main water pipes, not the refrigerator.
Ice maker
1
Feeler Arm
2
Test button
Check the water level
22_ setting up
DA99-02208A(0.1).indb 22 2009.11.17 1:23:49 PM
142


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG ka 2111 dl at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG ka 2111 dl in the language / languages: Dutch as an attachment in your email.

The manual is 19,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info