349322
138
Zoom out
Zoom in
Previous page
1/164
Next page
18_ setting up
3. After adjusting the doors, turn the nut
1
clockwise until it reaches the lower end of the
bolt, then tighten the bolt again with the wrench
3
to fix the nut in place
1
.
If you do not secure the nut firmly, the bolt may release.
CloseMain
Waterpipe
CloseMain
Waterpipe
NOGAP
3
2
1
Wrench
Bolt
Nut
CHECKING THE WATER DISPENSER LINE (OPTIONAL)
A water dispenser is just one of the helpful features on your new refrigerator. To help promote better health,
the water filter removes unwanted particles from your water. However, it does not sterilize or destroy
microorganisms. You will need to purchase a water purifying system to do that. In order for the icemaker to
operate properly, water pressure of 138 ~862 Kpa is required. Under normal conditions, a 170 cc paper cup
can be lled in 10 seconds. If the refrigerator is installed in an area with low water pressure (below 138 Kpa),
you can install a booster pump to compensate for the low pressure. Make sure the water storage tank inside
the refrigerator is properly filled. To do this, press the water dispenser lever until the water runs from the water
outlet.
Water Line installation Kits are included with unit. You can nd it in freezer drawer.
INSTALLING THE WATER DISPENSER LINE
ForInteriormodel
Parts for water line Installation
1

Waterlinexerand
screws
2
Pipeconnector
3

Waterline
4

WaterFilter
Connecting to the water supply line
1. first, shut off the main water supply line.
2. locate the nearest cold, drinking water line.
3. follow the Water line Installation Instructions in the
installation kit.
CAUTION
The water line must be connected
to the cold water pipe. If it is connected
to the hot water pipe, it may cause the
purifier to malfunction.
4. After connecting the water supply to the water lter, turn your main water supply back on and
dispense about 1l to clear and prime the water filter.
DA99-02208A(0.1).indb 18 2009.11.17 1:23:35 PM
138


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG ka 2111 dl at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG ka 2111 dl in the language / languages: Dutch as an attachment in your email.

The manual is 19,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info