692524
45
Zoom out
Zoom in
Previous page
1/116
Next page
Operation
45
GB
Changing the after-run time of the extraction system
Press simultaneously the extractor Plus key
and
Minus key . in order to change the time.
Cutting off the after-run of the extraction system
Press the ON/Off key of the extractor
.
NOTE
If the extraction system has been in operation for at
least 15 minutes, an automatic after-run of 15 minutes
at level 1 runs to dry out the system.
Disable automatic after-run
1. Turning on the control via the on/off switch on the fan
.
2. Press the on/off button on the fan for approximately
3 seconds until is displayed. The automatic fan
is permanently disabled.
Enable automatic fan run
1. Turning on the control via the on/off switch on the fan
.
2. Press the on/off button on the fan for approximately
3 seconds until is displayed. The automatic fan
run is permanently activated.
4.25.3 Notes on runtime
The fan motor should continue operating for another
10-20 minutes every time the hob has been used for
cooking. When the fan is switched off after having been
in operation for at least 15 minutes, an automatic time lag
at a low setting will follow for around 15 minutes.
This guarantees optimal functioning and the removal of
remaining cooking steam.
When using a recirculating air fi lter, please always
allow for a stop delay time of 10 - 60 minutes in order to
optimally remove cooking odours.
When the fan is switched on again, in rare cases the
odour molecules present in the fi lter may be combined
with steam so that they are detected again. These
remaining odours will disappear when the fan continues
to operate.
IMPORTANT
When the recirculation mode is in operation, ventilation
must be suffi cient in order for the air humidity to be
removed.
4.25.4 Indication: Clean the grease fi lters
After 10 hours of operation the display for fi lter
cleaning appears. The grease fi lter must be cleaned,
otherwise there is a risk of fi re.
To continue to use the ventilation, confi rm the display
with the Minus key .
If the grease fi lter has been cleaned, you can delete the
display by pressing the Minus key and the ON/
OFF key on the extractor at the same time for at least
3 seconds. The counter for the display starts again at 0
hours.
4.25.5 Indication: Replace the charcoal fi lter
After 150 hours of operation the display for Carbon
Cleaning appears . The charcoal fi lter needs to be
replaced.
To continue to use the ventilation, confi rm the display
using the Plus key to .
If the carbon fi lter has been replaced, you can delete
the display by pressing the Plus key and the ON/
OFF key on the extractor at the same time for at least
3 seconds. The counter for the display starts again at 0
hours.
4.25.6 Turn off the carbon fi lter operating hours
counter during the operation of the air exhaust
During the operation of the air exhaust, the operating
hours counter for the carbon fi lter must be turned off .
To do this, the control panel must fi rst be turned on using
the ON/OFF key of the fan and there may not be any
messages displayed.
Then simultaneously press the Plus key and the ON/
OFF key from the fan for 3 seconds.
The display will show (carbon off ) and the operating
hours counter for the charcoal fi lter is turned off .
To turn the operating hours counter back on, repeat the
operation.
The display will show (carbon on) and the operating
hours counter for the charcoal fi lter is now turned on.
45


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG HIDD8472LV at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG HIDD8472LV in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 5,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ATAG HIDD8472LV

ATAG HIDD8472LV Installation Guide - English, German, Dutch, French - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info