336583
31
Zoom out
Zoom in
Previous page
1/35
Next page
GB 26 GB 27
SYMPTOOM POSSIBLE CAUSE SOLUTION
e display will keep on
ashing after you have
switched on a cooking zone.
e pan you are using is
not suitable for induction
cooking. or has a diameter
smaller than 12 cm.
Use a suitable pan, see (refer
to pages 12 and 13).
A cooking zone suddenly
stops working and a beep can
be heard.
e set timer time has passed. Switch off the beep by
pressing any button.
e hob is not working and
nothing appears in the display.
ere is no power supply due
to a defective cable or a faulty
connection.
Check the fuses or the electric
switch (if there is no plug).
A fuse blows as soon as the
hob is switched on.
e hob has been wrongly
connected.
Check the electrical
connections.
e hob switches off without
warning.
You have accidentally pressed
the on/off button or operated
two buttons simultaneously.
Switch the hob back on.
Fault code ER22. e control panel is dirty or
theres water on it.
Cleaning the control panel.
Fault code E2. e hob has overheated. e hob has been switched off
due to overheating. Let the
hob cool down and then use
a lower setting.
Fault code U400 Voltage too high and/or not
connected properly.
Have your connection
changed.
Fault code
.
You have operated a button
too long.
Do not operate the buttons
too long.
Other fault codes. Defective generator. Contact the service
department.
GeneralTROUBLESHOOTING
Safety instructions for the installation
e connection must comply with national and local regulations.
e appliance must always be earthed.
is appliance may only be connected by a competent
electrical installer.
For the connection, use an approved cable (for example type
HO7RR) in accordance with the regulations.  e cable casing
should be of rubber.
e connection cable must hang freely and is not to be fed
through a drawer.
If you want to make a fi xed connection, make sure that a multi-
polar switch with a contact separation of at least 3 mm is fi tted in
the supply line.
e worktop the hob is built into must be fl at.
e walls and the worktop surrounding the appliance must be
heat resistant up to at least 85 °C. Even though the appliance
itself does not get hot, the heat of the hot pan could discolour or
deform the wall.
Damage caused by incorrect connection, installation or use, will
not be covered by the guarantee.
Clearance
Suffi cient all-round clearance is essential to the safe use of the hob.
Check that there is enough clearance.
cooker hood
cabinet
side wall
hob
GeneralINSTALLATION INSTRUCTIONS
*
HI6271T: min. 60 cm
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG hi 6271 t at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG hi 6271 t in the language / languages: English, Dutch as an attachment in your email.

The manual is 1,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ATAG hi 6271 t

ATAG hi 6271 t Installation Guide - English, German - 2 pages

ATAG hi 6271 t User Manual - German - 62 pages

ATAG hi 6271 t Installation Guide - Dutch, Danish, French - 2 pages

ATAG hi 6271 t User Manual - French - 62 pages

ATAG hi 6271 t Installation Guide - Swedish, Norwegian - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info