GB 7
controls
igniting and adjusting
GB 6
controls
igniting and adjusting
igniting
HG60..Q
1.
Push the control in and turn it to the full on position.
The burner lights automatically.
If the burner does not ignite within ± 10 seconds, the gas
supply is shut off and all the burners go out. The red indicator
light starts to blink. Turn all the control knobs to their "off"
setting and wait until the indicator light goes out. Then try
again. Now try to light the burner again.
If the burner blows out, it will automatically relight. If the
burner does not relight within approximately 10 seconds, the
gas supply is cut off and all the burners will go out.
If a burner refuses to light, always check:
– that the cover is properly aligned on the burner;
– that the burner is clean and dry.
adjusting
You may set the knob at any position between full-on and
simmer.
0 setting
high setting
low setting
burner indication
igniting HG60..P/HG40..P
1. Press the control knob in.
2. Turn the control knob carefully to the ignition zone.
The burner ignites.
3. Turn the control to the desired setting once the burner is
alight.
If the burner fails to ignite, check if:
– The burner cap is positioned correctly.
– The burner is clean and dry.
adjusting
You may set the knob at any position between full-on and
simmer.
attention!
You can only ignite the burner in the ignition zone.
0 setting
high setting
low setting
burner indication
ignition zone
