692538
36
Zoom out
Zoom in
Previous page
1/76
Next page
EN 18
General
If you notice a crack in the glass top (however small), switch the hob off immediately, unplug the
hob, turn off the (automatic) fuse switch(es) in the meter cupboard or, in the event of a permanent
connection, set the switch in the power supply lead to zero.) Contact the service department.
Troubleshooting table
If the appliance does not work properly, this does not always mean that it is defective.
Try to deal with the problem yourself first by checking the points mentioned below or
check for more information the website ‘www.atag.nl’.
Symptom Possible cause Solution
The display lights up when the hob
is activated for the first time.
This is the standard
set-uproutine.
Normal operation.
A slight smell is noticeable the first
few times the hob isused.
The new appliance is heatingup. This is normal and will disappear
once it has been used a few times.
Ventilate the kitchen.
A cooking zone suddenly stops
working and you hear a signal.
The preset time has ended. Stop the bleep by pressing the
timer key.
The hob is not working and
nothing appears in thedisplay.
There is no power supply due
to a defective cable or afaulty
connection.
Check the fuses or the electric
switch (if there is noplug).
A fuse blows as soon as the hob is
switched On.
The hob has been wrongly
connected.
Check the electrical connections.
Error code Er 03
The control panel is dirty or has
water lying on it.
Clean the control panel.
You have pressed two or more
keys at the same time.
Do not operate more than one key
at the same time.
Error code Er
Other defect Contact the service department.
In case of an operation failure or if the faults / error indication does not disappear,
disconnect the cooking hob from the power mains for a few minutes (undo the fuse or
turn of the main switch); then, reconnect it to the power mains and turn on the main
switch key. If the problems persist, call a service technician.
TROUBLESHOOTING
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG HC6471G at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG HC6471G in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ATAG HC6471G

ATAG HC6471G Installation Guide - English, German, Dutch, French - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info