507731
30
Zoom out
Zoom in
Previous page
1/37
Next page
Installation instructions S-HR series page 30
18 Error indication
When detected, errors are indicated on the display. Some, of a temporary nature, will not usually result in the boiler
locking out. Whilst the control system will try its utmost to prevent lockout, and may temporarily switch off the unit,
any fault which could potentially damage the appliance will result in lockout. The following are examples of mes-
sage display, which fall into two categories - i.e. Blocks and Errors.
Blocks with a number in the last 2 positions.
Block 01:
External safety contact cut out
Block 11:
Maximum 'T of flow and return sensor in central heating has repeatedly been exceeded. During the
block normal operation of the hot water supply is possible. The pump continues to operate at minimum
capacity during the block.
Block 12:
Maximum 'T of flow and return sensor in domestic hot water has repeatedly been exceeded. During
the block normal operation of the central heating installation is possible. During the block the pump
continues to operate at minimum capacity.
Block 60:
Incorrect parameter setting of the minimum or maximum power.
Block 67:
A 'T has been detected between flow and return sensor whereas the burner is not in operation. After
the 'T has disappeared the block will disappear.
Block 80:
Maximum flue gas temperature has been exceeded (if present). The block will not be cancelled until
the flue gas temperature has arrived below the temperature.
Block 81:
The flue gas sensor is not connected although it has been connected to the control. The burner is
blocked until the flue gas sensor is reconnected.
Block 82:
The flue gas sensor has short-circuited, heat requirement blocked and pump capacity at minimum.
Block 85:
The control has not detected a water flow. The venting cycle is started. If during this cycle water flow
is detected, the venting cycle is ended and the burner is released.
Error with a number in the last two positions.
Error 00: poor flame-forming
Error 01: short-circuit of 24 volt circuit
Error 02: no flame-forming
Error 03: temperature in airbox to high
Error 04: adjustment or error for voltage interruption
Error 05: fault control unit
Error 12: fuse 24 volt/3AT faulty
Error 19: maximum return temperature exceeded
Error 28: number of revolutions not reported back from fan
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG Blauwe Engel at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG Blauwe Engel in the language / languages: English as an attachment in your email.

The manual is 1,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ATAG Blauwe Engel

ATAG Blauwe Engel Manual - Dutch - 2 pages

ATAG Blauwe Engel Installation Guide - Dutch - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info