507731
23
Zoom out
Zoom in
Previous page
1/37
Next page
Installation instructions S-HR series page 23
- connect the digital pressure gauge hose to the
uppermost measuring nipple of the gas block
according to figure 13;
- activate the manual control by briefly pressing the
“-” key;
- take the fan to minimum load by means of the “-” key,
after which the measured pressure difference must
be between 0 and -4 Pa ;
- ending the manual selection is done by pressing the
“-” key until the minimum load is displayed. After
pressing this key again the text is shown
which means that the manual selection is off.
If it is determined that the zero pressure control deviates
too much, then it can be corrected by means of the
adjustment screw on the gas block.
13.3 Checking the CO
2
The CO
2
percentage is factory-set. This can be checked
by means of the following actions:
- put the boiler into operation by means of the service
chapter as described in chapter 11.2;
- place the lance of the CO
2
gauge in the location
according to figure 14;
- adjust to maximum load by means of the “+” key;
- ending the manual selection is done by pressing the
“-” key until the minimum load is shown. After pressing
this key again the text is shown which means
that the selection is off.
- adjust the CO
2
percentage according to table 12. The
CO
2
percentage can be adjusted by means of the
adjustment screw according to figure 15.
adjustment screw zero pressure control figure 13
measuring point for CO
2
figure 14
adjustment screw CO
2
figure 15
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG Blauwe Engel at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG Blauwe Engel in the language / languages: English as an attachment in your email.

The manual is 1,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ATAG Blauwe Engel

ATAG Blauwe Engel Manual - Dutch - 2 pages

ATAG Blauwe Engel Installation Guide - Dutch - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info