532085
19
Zoom out
Zoom in
Previous page
1/116
Next page
Syn248 Installation and Configuration Guide Back to Contents
Installation 18
Connect the Gateway to the Network:
1. Connect the supplied Cat.-5 LAN cable (or a comparable substitute) from your office
LAN to the Gateway LAN port.
Figure 7. Gateway Power and LAN Connections
2. Plug the AC plug into an electrical outlet not controlled by a wall switch and the DC
plug into the DC jack, as shown in Figure 7. Wait up to one minute until the screen
lights up.
The Gateway takes about a minute to power up. The Line LEDs blink for up to 15
seconds during initialization, then turn off.
After another Syn248 device is installed, and after the Gateway has found the
network and the other Syn248 device, Synchronized appears on the third line of
the display as shown in Figure 8. This is the Idle screen.
Figure 8. Gateway Idle Screen, Synchronized
An IP address beginning with 169.xxx indicates there is no DHCP server on the
network. Without a DHCP auto-assigned IP address (usually beginning with 192.xxx),
the Syn248 devices may not show the correct time and date and you may not be
able to access the WebUI to configure the system. You may have to set the time and
date manually from a Deskset. See “Set Time and Date” on page 83.
LAN
DC Power
Line LEDs
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AT-T SYN 248 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AT-T SYN 248 in the language / languages: English as an attachment in your email.

The manual is 2,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info