EN-20
Back
Return to upper level of OSD menu.
Image Setting (VGA)
Allow you to set images for VGA input signal.
Auto Adjust
Automatically determines the best picture timings for the displayed image.
Frequency
Adjust the timing of the projector relative to the computer.
Phase
Adjust the phase of the projector relative to the computer.
Horizontal Position
Adjust the image left or right within the projection area.
Vertical Position
Adjust the image up or down within the projection area.
Back
Return to upper level of OSD menu.
Setup
Allow you to change projector’s system setup.
Auto Keystone
Automatically correct distorted images resulting from an angled projection.
Lamp Power
Display the LED’s elapsed operating time (in hours).
Projector Position
Adjust the picture to match the orientation of the projector: upright or upside-down, in
front of or behind the screen. Invert or reverse the image accordingly.
Menu Timeout
Duration of OSD menu display countly starts (at idle state by second).
Power Timeout
Allows the projector to turn off if no input signal is detected after a set period of time.
• Never: The projector will not turn off no matter whether the projector is active or
inactive.
• Auto: The projector will turn off in 5 minutes from the time when the projector is
detected to be inactive.
