673144

Astralpool ASTRALPOOL HEAT II Manual

13
Zoom out
Zoom in
Previous page
1/196
Next page
ASTRALPOOLHEAT SERIES · AIR/WATER SYSTEM
ASTRALPOOLHEAT SERIES · AIR/WATER SYSTEMASTRALPOOLHEAT SERIES · AIR/WATER SYSTEM
ASTRALPOOLHEAT SERIES · AIR/WATER SYSTEM
© ASTRALPOOL 2015 ALL RIGHTS RESERVED. PROPRIETARY DOCUMENT.
Pag:
13
ENGLISH
ENGLISHENGLISH
ENGLISH
In order to obtain an optimal operation of the heat pump, certain norms must be respected:
•
••
• Use of free chlorine: 0.5 – 2 ppm.
•
••
• Bromine: 6.6 mg/l max.
•
••
• pH: Between 7.2 and 7.6
•
••
• Salt: 4-6 gr/l.
When backwashing the filter of the swimming pool filtration system, the heat pump must be
disconnected.
SPECIFIC
SPECIFIC SPECIFIC
SPECIFIC INSTRUCTIONS:
INSTRUCTIONS:INSTRUCTIONS:
INSTRUCTIONS:
It is obligatory for users contact a specialized company that has
experience installing and repairing heat pumps. Users should not install or repair the heat pump
themselves nor should another person do it.
The operating environment of the unit usually varies between 10 ºC and 35 ºC.
4.
4. 4.
4. START UP OF THE HEAT PUMP
START UP OF THE HEAT PUMPSTART UP OF THE HEAT PUMP
START UP OF THE HEAT PUMP
4.1.
4.1. 4.1.
4.1. INSTALLATION RULES
INSTALLATION RULESINSTALLATION RULES
INSTALLATION RULES
It is necessary to determine the unit location according to certain criteria:
• The unit must be secured on a firm and flat surface (concrete or hard steel frame type)
and must be protected from flood risk.
• The unit must be installed outdoors, taking advantage of the sun’s direct rays.
• Clearance space around the unit is necessary: 0.6 meters at the front, adequate for
servicing, and a minimum of 0.5 meters at the back and sides of the unit.
• If the heat pump is to be installed in a garage or under a vertical overhang, the unit
must have a minimum of 2.5 meters clearance at the top.
• The air caused by the helix must be directed away from the limits of the work
environment (windows, doors...).
• The minimum distance between the heat pump and the rim of the swimming pool must
be at least 3.5 meters (Electrotechnic Regulations for Low Voltage, Supplementary
Technical Instructions, Low Voltage, 31, ITC-BT-31).
• The electrical and hydraulic connections must be in accordance to the applicable
regulations (NF C 15 100, EC 1 364). The water tubing must be fixed.
• During normal operation of the heat pump, the evaporation coil will produce a certain
amount of water which has to be evacuated. The heat pumps are equipped with a 12
mm diameter adapter drain in 100/150 models and a 19 mm diameter barbed adapter
in 200/250/300 models. This drain is located on the side of the base plate and always
should be free of any obstruction.
• It is important to remember that no part of the tubing or hose may be above the level
of the drain hole in the base of the heat pump.
• This condensation water does not have to be treated in any special manner.
• Keep lawn sprinkler heads from spraying on the heat pump to prevent corrosion and
damage. Use a deflector if needed.
• Make sure the heat pump is not located where large amounts of water may run off
from a roof into the unit. Sharp sloping roofs without gutters will allow massive
amounts of rain water, mixed with debris from the roof, to be forced through the unit.
4.2.
4.2. 4.2.
4.2. HYDRAULIC CONNECTIONS
HYDRAULIC CONNECTIONSHYDRAULIC CONNECTIONS
HYDRAULIC CONNECTIONS
Remove the seals from the three piece connections of the water intake on the heat pump.
Connect the PVC 50 piping water inlets and outlets of the swimming pool to the heat pump inlet
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Astralpool ASTRALPOOL HEAT II at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Astralpool ASTRALPOOL HEAT II in the language / languages: English, German, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 8,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info