309069
27
Zoom out
Zoom in
Previous page
1/32
Next page
Before the machine is used, the three transport
protection devices should be removed as shown
below.
Each transport protection device consists of a
screw, a washer and a rubber spacer. After the
protection device has been removed, the rubber
spacer acts as a plug for the holes for the device
and also as a damper.
1.
First remove the screws and remove the
washers.
2.
Then remove the rubber spacers.
2
1
3.
Finally, the rubber spacers should be turned
over and replaced in the transport protection
device holes.
Note!
In order to prevent the machine from being dam-
aged when it is transported, use the transport
protection device, which locks the entire inner
compartment in place. If the transport protection
device is missing, you can order one from your
retailer.
Item number:
8064206 Rubber spacer
8901037 Bolt
8061767 Washer
Order three of each item!
27
Transport protection
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Asko w 6863 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Asko w 6863 in the language / languages: English as an attachment in your email.

The manual is 3,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info