Manual Ascaso elipse (page 13 of 46) (English, German, Dutch, French, Italian, Portuguese, Spanish)

361474

Zoom out

Zoom in

1/46

Versatile (pod/ground)

(versatile mobile system)

Pod coffee:

Points 1 and 2 as in the above section.

Use the specific filter holder

or Pod

filter (option). (See picture 4)

Points 5, 6, 7 and notes as in the above

section.

Ground coffee:

For ground coffee, fill the coffee filter

basket up to the rim (see picture 2B).

To tamp and fill the coffee again. Points

1.2.4.5.6 and 7 as in the above section.

Pod

(fixed holder-pod only).

Points 1 and 2 as in the section on

ground coffee.

Place the pod in the filter holder and

turn it gently to the right as far as it will

go. Do not exert force. Close gently.(see

picture 5) Points 5, 6, 7 and notes as in

the section on ground coffee.

Careful: Do not remove or turn the

filter holder while the water is passing

through as the appliance is at low

pressure at this moment.

Notes:

1 .The filter holder should always be

placed in the machine so that it

remains warm. Closed position.

2 .Place the cups on the cup warmer

. The right temperature (optimum

40ºC/105ºF) will improve the

espresso. (see picture 6)

3 .If the coffee does not come out very

hot, press steam switch

for 10

seconds. This will raise the

temperature of the machine.

4 .Coffee will continue to drip from the

spouts for a moment after the coffee

swich is turned off.

5 .It is normal for the coffee grounds to

be very wet or a soup-like

consistency if the filter holder is

removed within one to minutes after

brewing.

THERMOMETER

The thermometer will mark you the

machine temperature. It has to be in

between 80ºC/180ºF and 110ºC/230ºF

for coffee and above 100ºC/212ºF

degrees for steam

Important: Tamped

The best espresso result are

obtained when the ground coffee is

firmly tamped.

5-. Preparation of cappuccino

Mobile filterholder

1-.

Press general switch

. Pilots

and

(Dream) and

and

(Arc,

Elipse, Basic) will come on.

2.-When pilot 6 goes out, press steam

switch

. Pilots

(all models) and

(Dream) will go out.

3.-

Wait for light

to go out. This

indicates that the coffee machine has

reached its ideal temperature.

4-.

Turn the hot water/steam knob

open and allow the first drops of

water to come out. In a few moments,

only steam will come out.

5-.

Put the tube

into the milk to heat

it so that the milk covers exactly half

the absorption hole (never totally

cover it). Do this for the whole

process. (see picture 7)

6.-Liquid is absorbed through the hole

and cream forms automatically.

The recipient should be lowered

gradually while the milk emulsifies.

7.-

Turn the water/steam knob

closed - and turn off the steam switch

Fixed filterholder

1-.

Press general switch

. Pilots

and

(Dream) and

and

(Arc,

Elipse, Basic) will come on.

2.-

When pilot

goes out, press steam

switch

. Pilots

(all models) and

(Dream) will come on

simultaneously and the pump will be

pressed at short intervals.

3.-Wait for approximately 15 and then

open side knob

and let the first

drops of water run out. After a

moment only steam will come out.

Points 5, 6 and 7 are the same as in

the previous section.

If you want a creamy cappuccino, use

cold, fresh, whole milk.

If you want hot milk (without emulsifying)

the hole must be completely covered.

ascaso ascaso

ENGLISH

Picture 4

ABSORTION ORIFICE

IN THE UPPER SIDE

OF THE TUBE

CLEAN IT AFTER USE.

Picture 7

Picture3

Picture 5

Picture 6

DREAM

ARC

BASIC

ELIPSE

Picture 6

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Ascaso elipse in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 1,53 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Ascaso elipse Manual

Product: