736659
19
Zoom out
Zoom in
Previous page
1/44
Next page
19
Check engine oil level
(4-stroke devices)
Attention! Prior to each use, check the engine
oil level (see operating instructions of the en-
gine manufacturer).
To ensure sufficient oil supply for the four
stroke engine and to avoid resulting engine
damage, the device may only be used on
slopes up to 20°.
Tanking up
Warning
Fuel is ignited by hot engine parts.
Prior to filling up, switch off the engine
and wait for at least 20minutes until the
engine has cooled down. Observe the
safety instructions regarding the fuel!
Warning
The fuel tank at the engine is not connec-
ted.
Filled fuel can run out and ignite.
Never fill fuel into the tank on the engine.
Filling up with fuel
1. For filling, use a canister with filler spout or
a funnel.
2. Open the canister carefully so that existing
excess pressure is slowly reduced.
3. Open the tank cap carefully so that existing
excess pressure is slowly reduced and no
fuel sprays out.
4. Fill the fuel tank.
5. Tightly close the tank cap again.
Adjusting the cutting height
Adjust the cutting height setting only when the
engine is switched off.
Set the cutting height so that the blade does
not touch the ground even in case of terrain
unevenness. If the cutting height is set too
high, objects can be ejected and the “clean cut
appearance” can be destroyed.
The cutting height can be adjusted in 1 cm in-
crements from 3cm to 8cm.
1
2
Fig.6:
1. Switch off the engine and wait until the
blade has come to a standstill.
2. With the adjusting lever(1) adjust each
wheel to the same cutting height. While do-
ing so, adjust wheel after wheel only by
one position at a time.
Setting the cutting height
Under high load, adjust the cutting height by
tightening the screw(2).
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AS Motor AS 531 2T ES MK B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AS Motor AS 531 2T ES MK B in the language / languages: English as an attachment in your email.

The manual is 1,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of AS Motor AS 531 2T ES MK B

AS Motor AS 531 2T ES MK B User Manual - German - 44 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info