736665
30
Zoom out
Zoom in
Previous page
1/40
Next page
30
8
7
13
10
11
9
14
15
8. Turn the bow holding device(7) up to the
centre.
9. Push the steerable front wheel(8) with the
tube end through the bow holding
device(7) and insert it into the guide
bar(15).
10. Screw down the steerable front wheel with
the toggle screw(14).
11. Hang the protection skirt into the screws(9)
on the blade hood and screw it down with
washers and nuts.
12. Screw down the protection bow and the
protection skirt at theright side of the blade
hood(10) with a washer and a retaining
nut.
13. Insert the rear screw M6 at the side
panel(11) and screw down the protection
bow and the protection skirt.
14. Fasten the protection skirt at the protection
bow with the cable ties(13). Use one cable
tie for each opening provided in the protec-
tion skirt.
15. Close the overlapping protection skirt with
a cable tie.
Storage
Storing the device
Keep the device in a closed, dry, and well vent-
ilated room and out of reach of children. Al-
ways eliminate all problems of the device be-
fore you store it so that the device is always in
a safe-to-operate state. Let the engine cool
down before you store the device in closed
rooms.
Also observe the notices on storage in the at-
tached operating instructions by the engine
manufacturer.
Longer storage
1. Observe the safety instructions for hand-
ling the fuel.
2. Emptying fuel tank. Place a piece of hose
onto the fuel valve and let the fule run into
an approved fuel container.
3. Emtyping carburetor: Start the engine and
let it run until it stops by itself.
4. Thoroughly clean the device.
5. Touch up any possible damage to the
paint finish (for paint, see Accessories).
Before longer storage, e.g. in the fall, have an
authorised service centre check the device!
Also observe the notices on storage in the at-
tached operating instructions by the engine
manufacturer.
Restarting
If you want to start the device after a longer
storage, carry out the tasks described in
chapter Maintenance.
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AS Motor AS 21 4T B S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AS Motor AS 21 4T B S in the language / languages: English as an attachment in your email.

The manual is 1,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of AS Motor AS 21 4T B S

AS Motor AS 21 4T B S User Manual - German - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info