636073
39
Zoom out
Zoom in
Previous page
1/60
Next page
FP/FR1100/1200/2000 V6: Installation and Commissioning Manual 37
6.3.2 RS232 ports
The two RS232 ports are provided with DB25 male connectors. The location of the
connectors is shown in Figure 3 & Figure 7. The signals at both the connectors are as
follows:
PIN NR Signal name
1 DCD
2 RXD
3 TXD
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 RI
" To route the RS232 cable inside the cabinet, refer to section 4.
When connecting the null-modem cable, the pins on both sides of the cable must be
connected as follow:
Signal DB25 (Panel Side) -
Female
DB25 (PC Side) -
Female
DB9 (PC Side) -
Female
Signal
TXD 2 3 2 RXD
RXD 3 2 3 TXD
RTS 4 5 8 CTS
CTS 5 4 7 RTS
DSR 6* 20 4 DTR
DTR 20 6** 6*** DSR
DCD 8* 8** 1*** DCD
RI 22* 22** 9*** RI
GND 7 7 5 GND
* Pins must be connected
** Pins must be connected
*** Pins must be connected
39


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aritech FP-FR1200 Series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aritech FP-FR1200 Series in the language / languages: English as an attachment in your email.

The manual is 4,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info