636073
19
Zoom out
Zoom in
Previous page
1/60
Next page
FP/FR1100/1200/2000 V6: Installation and Commissioning Manual 17
CAUTION! Mains wires (230 V) must enter the cabinet from the right bottom hole in the
cabinet only.
Top entry violates IEC950 safety requirements and will cause EMC
problems.
Mains wires must not be routed past the electronic modules in the rear of the panel. It
must be kept as short as possible and routed directly to the mains input.
4.1.3 Panel & repeater layout
Figure 3: Panel layout
A. FP1216EN & FP1264 16. Host CPU board
B. FR1200 & FR2000 17. DB-9 port
1. Transformer 18. RS232 and current loop routing of wires
2. Battery link 19. ARCNET network card (top) (optional)
3. Battery terminal (+) (red) 20. Battery terminal (-) (black)
4. Mains terminal block 21. Battery and power supply connection terminals
5. Earth stud 22. Modem (MOD2000) power supply terminals
6. Main fuse and switch 23. Front-end processor board
7. Batteries 12V (2x) (optional) 24. Power supply board
8. Zone matrix display board (bottom) (optional) 25. Fault relay connections
9. Common LED board 26. Auxiliary power connections
10. Service commission mode select 27. Loop 1-4 terminal connections
11. Non-volatile memory lock 28. 2 Loop driver board
12. Memory back-up battery jumper 29. Sounder relay board
13. Numeric keypad 30. Modem (MOD2000) (optional)
14. LCD display 31. ARCNET network card (bottom) (NC2011)
15. Current loop terminals
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aritech FP-FR1200 Series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aritech FP-FR1200 Series in the language / languages: English as an attachment in your email.

The manual is 4,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info