455109

Ariston XC 95 MK Manual

16
Zoom out
Zoom in
Previous page
1/32
Next page
14
Supply voltage and frequency 230V~ 50-60 Hz
Maximum electrical input: 10800W
This appliance conforms with the following European
Economic Community directives:
- 73/23/EEC of 19/02/73 (Low Voltage) and subsequent
modifications;
- 89/336/EEC of 03/05/89 (Electromagnetic Compatibility)
and subsequent modifications;
- 93/68/EEC of 22/07/93 and subsequent modifications.
TECHNICAL SPECIFICATIONS
Connecting the supply cable to the mains
Fasten the appropriate standard plug for the load indicated
the rating plate to the chord. If the appliance must be directly
connected to the mains, a multipolar switch must be installed
between the appliance and the mains. The multipolar switch
must have a minimum of 3 mm of space between the
contacts, be sized to the load, and comply with current
regulations (the switch must not be able to disconnect the
earth conductor). The supply cord must be positioned so
that no part of it reaches a temperature of 50 °C higher than
room temperature. Before making the connection, make sure
that:
• the limiter valve and the residential wiring can support
the appliance load (see rating plate);
• the mains system is properly earthed in compliance with
current regulations and provisions;
• there is easy access to the socket or the multipolar switch
after the appliance is installed.
Attention: If the cooktop is installed above a built-in oven,
the electrical connection for the cooktop must be
independent of that for the oven, both for safety reasons
and to facilitate the removal of the oven for maintenance,
repair, etc.
Electrical connection
THE APPLIANCE MUST BE EARTHED
The cooktop is designed to work with alternating current at
the supply voltage and frequency indicated on the rating plate
(situated under the hob or at the end of the instruction
booklet). Make sure that the local supply voltage corresponds
to the voltage indicated on the rating plate.
The electrical cooktop is not supplied with a power supply
chord because the type of chord used depends on the type
of electrical connection (see the following connection
diagram).
Use a rubber cable of the type H05RR-F.
Open the terminal box following the instructions illustrated
in the diagram below:
2
1
1
2
3
4
5
V
To connect the supply chord, proceed as follows:
• Loosen the screws on the wire clamp "V", as well as the
screws for the contacts.
• Insert the wires beneath the contact screws, as shown in
the diagram, and tighten them.
• Fasten the chord with the appropriate wire clamp and
close the cover.
For trouble-free operation of appliances installed in units,
the minimum distances shown in fig.7 should be observed.
Adjacent surfaces and the wall at the rear should also be
able to withstand a temperature of 65 °C. The cooker is fitted
with 4 height adjustable screw-in feet to level the cooker if
necessary. It is essential that the cooker stand on a flat
surface. Any deformation caused by bad positioning risks
modifying the appliance's characteristics and performance.
fig.7
V
Electrical
Connection
Power supply voltage
Fuse
Section
L
12345
N
L1L2L3
L1L2
1
1
2
2
3
3
4
4
5
5
N
N
L1
12345
L2
L1L2
12345
L3
L1L2
12345
N1N2
230V-1+N~50Hz
400V-3+N~50Hz
32A* 4 mm
2
25A 2,5 mm
2
16A* 1,5 mm
2
32A* 4 mm
2
25A 2,5 mm
2
25A* 2,5 mm
2
400V-2+N~50Hz
230V-2~50Hz
230V-3~50Hz
230V-2+2N~50Hz
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ariston XC 95 MK at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ariston XC 95 MK in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 1,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info