719976
7
Zoom out
Zoom in
Previous page
1/24
Next page
7 / EN
This product is a device that must be installed vertically in order to operate correctly. Once installa-
tion is complete, and before any water is added or the power supply is connected, use a measuring
instrument (i.e. a spirit level) to check that the device has been installed perfectly vertical.
The appliance heats water to a temperature below boiling point. It must be linked up to a mains water
supply according to the appliance performance levels and capacity.
Before connecting the appliance, it is fi rst necessary to:
- Check whether the characteristics (please refer to the data plate) meet the customer’s requirements.
- Make sure the installation conforms to the IP degree (of protection against the penetration of liquids)
of the appliance according to the applicable norms in force.
- Read the instructions provided on the packaging label and on the appliance data plate.
This appliance was designed to be installed only inside buildings in compliance with the applicable
norms in force. Furthermore, installers are requested to keep to the following advice in the presence of:
- Damp: do not install the appliance in closed (unventilated) and damp rooms.
- Frost: do not install the appliance in areas where the temperature may drop critically and there may
be a risk that ice may form.
- Sunlight: do not expose the appliance to direct sun rays, even in the presence of windows.
- Dust/vapours/gas: do not install the appliance in the presence of particularly dangerous substances
such as acidic vapours, dust or those saturated with gas.
- Electrical discharges: do not install the appliance directly on electrical supplies that aren’t protected
against sudden voltage jumps.
In the case of walls made of bricks or perforated blocks, partition walls featuring limited static, or mason-
ry di erent in some way from those stated, you fi rst need to carry out a preliminary static check of the
supporting system.
The wall-mounting fastening hooks must be designed to support a weight that is three times higher than
the weight of the water heater fi lled with water.
Fastening hooks with a diameter of at least 12 mm are recommended.
To facilitate maintenance, make sure there is a clearance of at least 50 cm inside the enclosure for ac-
cess to the electrical equipment.
PLUMBING WARNING:
Note: If a valve i.e. a non return valve, water meter, pressure reducing valve or any type of valve or
tting that acts as a non return valve is installed on the cold water mains, this will prevent expansion.
Therefore it will be necessary to install an expansion vessel (see fi gure below).
Note: If in doubt always install a pressure reducing valve (limited to 3.5bar) and expansion vessel.
The outlet from temperature and pressure relief valve/pressure relief valve must not be for any other
purpose.
Take great care not to allow any swarf into the pipe work or fi ttings, as this might impair the operation of
the safety valve(s). The water connection may be carried out as per the following:
7


Need help? Post your question in this forum.

Forumrules
1

Forum

ariston-velis-evo-wi-fi

Reset search

  • Can my Ariston net water heater be turned on and off and controlled without WiFi? Submitted on 15-3-2023 at 17:10

    Reply Report abuse
  • If I have the Ariston net, can it only be used via WiFi or is there a manual way to turn it on and off (in case the WiFi is down?) Submitted on 15-3-2023 at 17:09

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ariston Velis Evo Wi-Fi at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ariston Velis Evo Wi-Fi in the language / languages: English as an attachment in your email.

The manual is 1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ariston Velis Evo Wi-Fi

Ariston Velis Evo Wi-Fi User Manual - German, Polish - 106 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info