719590

Ariston Pro 1 Eco Manual

6
Zoom out
Zoom in
Previous page
1/18
Next page
Water Regulations and Byelaws
These regulations and byelaws ensure a good supply of wholesome water, and that only approved materials, pipes and
fittings are used to convey water.
Building Regulations
These are a statutory document and take priority over all other regulations and recommendations. The installation of an
unvented hot water system of over 15 litres is classified as a “Controlled Service” and Regulation G3 applies. To meet the
requirements of the regulation, installation of an unvented system should be undertaken by a “competent installer”.
All installations of unvented hot water storage systems having a capacity of more than 15 litres should be notified to the
relevant Local Authority by means of building notice or by the submission of full plans. It is important to note that it is a
criminal offence to install an unvented hot water storage system over 15 litres without notifying the Local Authority.
Delivery
The products are supplied with the following:
Unvented water heater (with factory-fitted T&P) x1
Pressure relief valve set at 6 bar x1
Dielectric junctions x2
Tundish x1
Expansion Vessel x1
Check Valve x1
Pressure reducing Valve x1
Important note: Dielectric junctions must be fitted to all models as they prevent an electrolytic reaction and safe
-
guard against potential aggressive corrosion.
If the supplied Dieletric Junctions are not tted this could void the warranty.
INSTALLATION NORMS (for the installer)
Before installing the heater read these instructions in full. If you are unsure please contact our technical service
department (03332407777).
The installation must comply with all relevant Water Regulations/Byelaws and Building Regulations.
The installer should check with the local water authority for conrmation of the maximum water supply pres
-
sure.
The appliance should be left packed until it is ready to be installed. When unpacking take care not to damage the
temperature and pressure relief valve on the top of the heater.
A drain has to be provided for any water discharged through the safety valves.
A cold water supply pressure between 1 and 3.5 bar is required (if the mains pressure is above 3.5 bar a pressure reduc
-
ing valve must be installed). Please note that turning down the stop-cock will reduce ow not pressure.
The outlet pressure from the reducing valve (if supplied) is 3.5 bar.
A 240 VAC; 3 kW single phase electrical supply is required.
This product is a device that must be installed vertically in order to operate correctly. Once installation is com
-
plete, and before any water is added or the power supply is connected, use a measuring instrument (i.e. a spirit
level) to check that the device has been installed perfectly vertical. The appliance heats water to a temperature
below boiling point. It must be linked up to a mains water supply according to the appliance performance levels and
capacity. Before connecting the appliance, it is rst necessary to:
- Check whether the characteristics (please refer to the data plate) meet the customer’s requirements.
- Make sure the installation conforms to the IP degree (of protection against the penetration of liquids) of the appli-
ance according to the applicable norms in force.
- Read the instructions provided on the packaging label and on the appliance data plate.
This appliance was designed to be installed only inside buildings in compliance with the applicable norms in force.
Furthermore, installers are requested to keep to the following advice in the presence of:
- Damp: do not install the appliance in closed (unventilated) and damp rooms.
… 6 …


Need help? Post your question in this forum.

Forumrules
1

Forum

ariston-pro-1-eco

Reset search

  • How to adjust the temp as it keeps returning to full temp Submitted on 13-8-2022 at 11:02

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ariston Pro 1 Eco at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ariston Pro 1 Eco in the language / languages: English as an attachment in your email.

The manual is 1,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ariston Pro 1 Eco

Ariston Pro 1 Eco User Manual - Dutch - 16 pages

Ariston Pro 1 Eco User Manual - French - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info