Manual Ariston PO 740 ES IX (page 61 of 70) (English, German, Dutch, French, Italian, Portuguese, Spanish)

455092

Zoom out

Zoom in

1/70

Installation Instructions for built-in

Installation of Built-in Cooktops

a) If the cabinet(s) located next to the cooktop are higher

than the cooktop itself, the cabinet(s) must be installed

at least 600 mm from the edge cooktop;

b) Hoods must be installed in accordance with the

instructions contained in the installation manual for the

hoods themselves, and no less than 650 mm from the

cooktop;

c) In the case of the 600 mm cooker hoods, besides

following the recommendations in point b), the cabinets

should be positioned next to the hood at a height of at

least 540 mm from the top since this will make it

possible to install the lid and move it correctly. The

cabinet should always be installed at a height from the

top which allows easy use of pots and pans on the

cooker.

d) Should the cooktop be installed directly under a

cupboard, the latter should be at least 700 mm

(millimetres) from the top, as shown in Figure.

600mm min.

540mm min.

700mm min.

e) The dimensions of the cutout for the appliance must

be those indicated in the figure. Clamps are provided

to fasten the cooktop to counters measuring from 20

to 40 mm in thickness. To fasten the cooktop securely,

it is recommended that all the clamps be used.

555

475

Fastening Clamps - Assembly Diagram

Clamp Position for Clamp Position for

H=20mm top H=30mm top

Front

Clamp Position for

H=40mm top Back

N.B: Use the clamps contained in the "accessory kit."

f) In the event the cooktop is not installed above a built-

in appliance, a wood panel must be inserted as

insulation. This panel must be placed at least 20 mm

from the bottom of the cooktop itself.

Connecting the gas

The appliance should be connected to a gas cylinder in

compliance with current directives. On some models the

gas supply can be connected on the left or on the right,

as necessary; to change the connection, reverse the

position of the hose holder with that of the cap and replace

replace the gasket (supplied with the appliance).

Remember to install a pressure regulator on the LPG

cylinder, which complies with current directive.

Important: check that the supply pressure complies with

the values indicated in table 1 “Characteristics of the

burners and nozzles” since this will ensure safe operation,

correct consumption and ensure a longer life to your

appliance.

Connection with hose

Make the connection using a gas hose complying with

the the characteristics provided in current directive. The

internal diameter of the pipe used is as follows:

- 8mm for liquid gas;

When installing the hose, remember to take the following

precautions:

Check that the hose fits firmly into place at the two ends

and fix it with clamps complying to current directive.If any

of the above recommendations can not be adopted, flexible

metal pipes should be used.

Tight control

Important: when installation has been completed, check

the pipe fitting for leaks with a soapy solution. Never use

a flame. Once the connection has been made, ensure that

the flexible metal tube does not touch any moving parts

and is not crushed.

Regulation of Air Supply to the Burner

The burners do not need a primary air regulator.

Connecting the supply cable to the mains

Install a normalised plug corresponding to the load

indicated on the data plate. When connecting the cable

directly to the mains, install an omnipolar circuit-breaker

with a minimum contact opening of 3 mm between the

appliance and the mains. The omnipolar circuit breaker

should be sized according to the load and should comply

with current regulations (the earth wire should not be

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Ariston PO 740 ES IX in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 2,34 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Ariston PO 740 ES IX Manual

Product: