Manual Ariston LI 480 A (page 21 of 80) (English, German, Dutch, French, Italian, Portuguese, Spanish)

454485

Zoom out

Zoom in

1/80

ARISTON DISHWASHER - Instructions for installation and use

ISHWASHER

If the power

socket to which

the appliance is

connected is not

compatible with

the plug, replace

it with a suitable

plug rather than

using adapters or

multiple plugs as

these could cause

overheating or

burns.

Installation and moving

After having bought or moved your dishwasher to another home, a

correct installation ensures that your dishwasher will operate

smoothly and efficiently.

Your dishwasher has arrived

Hot water connection.

Your dishwasher can be supplied

with hot water from the mains

supply (if you have a central heating

system with radiators) at a tempe-

rature of no more than 60°C.

In this case, the wash cycle time

will be about 15 minutes shorter

and the wash will be slightly less

effective.

The connection must be made to

hot water supply following the

same procedures as those indicated

for the cold water connection.

Anti-flooding protection

Your dishwasher is provided with a

special system which blocks the

water supply in the event of leaks

inside the appliance. It is further

equipped with a water inlet hose

that can withstand extremely high

pressures and that turns bright red

in the event of breakage. Safety in

the event of flooding is ensured by

the second clear hose that contains

the former and thus highlights the

latter when it has turned bright red.

It is vital that you check it on a

regular basis: if you see it has turned

bright red, then you know you have

to replace it as soon as possible.

Call for an authorised technical

engineer to come and replace it.

Drain hose connection.

Fit the drain pipe into a drain line

with a minimum diameter of 4 cm

or place it over the sink. Avoid

restricting or bending it. The part

of the pipe marked with the letter

A should be between 40 and 100

cm above the ground.

The pipe should not be immersed

in water.

Electrical connection.

First of all, check that the mains

voltage and frequency values

correspond to those stated on the

rating plate located on the stainless

steel inner door of the appliance

and that the electrical system to

which the dishwasher is connected

is sized for the maximum current

indicated on said rating plate.

Earth: indispensable

safety.

Only now can you plug the

appliance into a socket provided

with an efficient earth connection

(the system's earthing is a

guarantee of safety provided for by

law, make sure your system has

it).

Choose where you want to install

your dishwasher, you can even

place it so that its sides or back

panel are side by side with furniture

or up against the wall. The

dishwasher is provided with water

supply and drain hoses, which can

be directed towards the left or right

to facilitate appropriate

installation.

Levelling.

Once the appliance is positioned,

adjust the feet by screwing them

in or out depending on how high

you want it and to level it so that it

is horizontal. Make sure that it is

not inclined more than 2 degrees.

If the appliance is level, it will he

lp ensure its correct operation.

Adjusting the Back Feet

Insert the appliance into the cutout

and then adjust the height using the

screws located on the front bottom

part of the machine. Use a

screwdriver to turn the screws in

the clockwise or anti-clockwise

direction to increase or decrease

the height respectively.

Cold water connection.

Connect the cold water supply

hose to a 3/4 gas threaded

connection, taking care to screw it

tightly onto the tap. If the water

hoses are new or have been out of

use for an extended period of time,

let the water run to make sure it is

clear and free of impurities before

making the connection. If this

precaution is not taken, the water

inlet could get blocked, causing

damage to your dishwasher.

The plug

The dishwasher plug must be

accessible even when the appliance

is installed as a built-in unit so that

maintenance can be done safely.

Power supply wire.

Check the power supply wire on a

regular basis; if it is damaged, we

recommend you have it replaced

by an authorised technical

Assistance service centre.

Antinoise protection

(where present)

- On top of the dishwasher you will

find two self-adhesive sponges.

- Glue the small sponge onto the

top cross-rod as shown in

photograph 1.

- Tilt the appliance and glue the

large sponge as shown in

photograph 2.

Both sponges must be applied

ensuring that they stick properly to

the plate.

Condensation-proof tape.

On some models, a transparent

condensation-proof adhesive tape

has been provided.

It should be stuck onto the lower

side of your wooden worktop to

protect it from the formation of

condensation.

When not provided, this tape can

be requested as a spare part from

authorised retailers.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Ariston LI 480 A in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 13,55 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Ariston LI 480 A Manual

Product: