47709
10
Zoom out
Zoom in
Previous page
1/12
Next page
21
GB
Transit packing
After removing the packing, check the appliance for damage.
If you have any doubts do not use the washer and call a
qualified technician. Keep the packaging components (plastic
bags, polyester foam, nails etc.) out of the reach of children
since they could be dangerous. The interior of the washer,
has an oscillating unit which is fixed on the back by 3 screws
during transport (figure 3). Before starting up the washer,
release the unit, by unscrewing the 3 screws. Seal the screw
holes with the plastic plugs supplied with the appliance.
Levelling
The machine must be level in order to operate properly, To
level the machine, simply regulate the adjustable feet (fig. 4);
the angle of inclination (measured on the top of the machine)
must not exceed 2 degrees. If the washer is installed on a
carpeted floor, check that there is sufficient ventilation space
between the floor and the bottom of the machine.
Water supply
Make sure that the water pressure is between the maximum
and minimum values indicated on the data plate located on
the back of the washer. Connect the inlet hose to a cold
water tap with a 3/4 gas threaded opening, and fit the filter
and the rubber gasket supplied with the washer. Check that
it is tightly screwed to the tap (see fig. 5). If the water piping
is new or has not been udes for a long time, before making
the connection, let the water run until it is clear and free
from impurities. This step is necessary to ensure that the
incoming water does not clog and possibly damage the
washer. Connect the other end of the pipe to the appliance,
at the top on the right, by the water connection (see fig. 6).
Installation
A
Fig. 5
Fig. 6
Connecting the drain pipe
Connect the drain hose to a drain (with a minimum inner
diameter of 4 cm), avoiding excessive crimping or the
formation of elbows. It is important that the hose be
positioned at a height greater than 60 cm. If this is not the
case, the hose must be fastened to the hook located on the
top part of the back of the machine (fig. 7).
If a drain pipe coming from the wall is used to connect the
hose, have a qualified plumber/technician check to make
sure that it functions properly. If your home is on the top of
an apartment building or condominium, the drain may be
subject to a siphoning effect which results in the machine
filling and draining continuously. To eliminate this
inconvenience, special valves are available on the market
which can be fitted to the drain hose.
Electrical connection
Before connecting the appliance to the mains, check the
following:
1) your mains socket must support then maximum power
load of the appliance, which is shown on the data plate; in
addition the socket must comply with legal regulations;
2) the supply voltage must correspond to the values shown
on the data plate;
3) the socket must be suitable for the plug of the appliance;
replace the socket or the plug but do not use an adapter;
4) home electrical systems must be earthed, in compliance
with ministerial directives. Should the electric system of your
home not comply with these directives, the manufacturer
declines any liability for any possible consequences.
Fig. 7
Fig. 3
Fig. 4
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ariston LB6TX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ariston LB6TX in the language / languages: English as an attachment in your email.

The manual is 0,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info