48024
9
Zoom out
Zoom in
Previous page
1/43
Next page
9
Installation
These instructions are intended for the qualified technician
installing the appliance in order to insure that the
installation, adjustments and maintenance procedures are
performed correctly and comply with the regulations
currently in effect.
Important: the cooktop must be disconnected from
the power supply before making any adjustments or
performing any maintenance, etc.
Installing built-in cooktops
The cooktops have a type X protection rating against
overheating in compliance with regulation CEI 335-2-6.
Therefore, the cooktops cannot be installed alongside of
cabinets which are higher than the surface of the cooktop
itself. The following precautionary measures should be
observed in order to ensure proper installation:
a) Hoods must be installed in compliance with the required
specifications contained in the instruction manual for
the hood itself.
b) The built-in ceramic glass top can be installed on any
counter top as long as it is 600 mm or more in width
and resistant to temperatures of up to 100°C.
The dimensions and the position of the hole are shown
in fig..
560 +/- 1
490 +/- 1
48
595
510
X (CEI 335-2-6)
The aforementioned measurements must absolutely
be observed in so far as improper installation can cau-
se the surrounding surface areas to overheat.
It is recommended that the cooktop be installed at a
distance of at least 40 mm from the back wall or other
vertical surfaces to ensure that the air circulates
properly over the cooking area and to avoid overheating
the surrounding surfaces. A seal or gasket is provided
with the cooktop; make sure that it adheres properly to
the bottom part of the frame of the cooktop.
It is indispensable that the seal fits properly around
the entire cooktop frame and especially along the
corners in order to create a seal between the counter
top and the cooktop itself so as to prevent spills or
splashes from leaking into the cabinet below.
Very important
It is essential to instali the hob on a totally flat surtace. Any
damage caused by incorrect fitting may alter the
characteristics or impair performance.
Insert the cooktop into the hole, pressing firmly around
the frame to make it adhere to the counter top.
Make certain that the seal around the outside edge of
the hob is correctly installed in order to avoid any
leakage into the cabinetry below.
The four securing springs are held in place by 4 Torx
screws.
To remove the hob unit from its housing, undo the 2 Torx
screws at the front, then the 2 Torx screws at the rear.
The 4 screws should be accessible at all times for this
purpose.
FRONT RIGHT MOUNTING
FRONT LEFT MOUNTING
SEAL MOUNTING
FRONT / REAR RIGHT / LEFT
MOUSSE 5x8 mm
HOB UNIT FACE DOWN
REAR RIGHT MOUNTING
WORK
SURFACE
REAR SPRING ASSEMBLY
FRONT OF THE HOB UNIT
30
40
REAR LEFT MOUNTING
c) If a wooden panel is installed beneath the cooktop
for insulation purposes, it must be positioned at least
20 mm from the bottom part of the cooktop itself.
Note: If the cooktop is installed above a built-in oven, it is
preferable that the oven be installed in such a way that it
is set on two strips of wood; if, on the other hand, the oven
is installed on a continuous base, there must be an opening
in the back of at least 45 x 560 mm.
560 mm.
45 mm.
The built-in oven must be equipped with a
forced air cooling system.
10
Leave this much
space between
the bottom and
the cabinetry
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ariston KT 6104 QD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ariston KT 6104 QD in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ariston KT 6104 QD

Ariston KT 6104 QD User Manual - Dutch - 6 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info