Manual Ariston KBT 6013 ID (page 28 of 60) (English, German, Dutch, French, Italian, Portuguese, Spanish)

454986

Zoom out

Zoom in

1/60

Electrical connections

Voltage,

Frequency

Fuses,

Sections

FR-AT-BE-DE-GP--

ES-IE-IL-IS-IT-LU-

RE-FI-GB-GR-PT--

SE-MA-NZ

230V-1+N~50 Hz

25 A*

2,5 mm²

FR-BE-NO

230V-2~50/60 Hz

25 A*

2,5 mm²

FR-BE-CH-DE-AT--

ES-IL-IT-NZ-PT-

MA- LU-SE-IS-NL

400V2-N~50 Hz

16 A*

1,5 mm²

FR-BE-NO

230V3~50 Hz

16 A*

1,5 mm²

FR-AT-BE-DE-ES-

IL-IS-IT-LU-PT-SE

-MA-NZ-CH-DK-N-

400V3+N~50 Hz

16 A*

1,5 mm²

230V2+2-N~50 Hz

16 A*

1,5 mm²

CY-AU-NZ-KW-MT

240V-1+N~50 Hz

25 A*

2,5 mm²

* Application of the simultaneity coefficient in accordance with

cei 60335-2-6 norm

Technical characteristics

This appliance conforms with the following European

Community Directives:

- 73/23/EEC of 19/02/73 (Low Voltage) and subsequent

amendments;

- 89/336/EEC of 03/05/89 (Electromagnetic compatibility)

and subsequent amendments;

- 93/68/EEC of 22/07/93 and subsequent amendments;

Warning: If the hob is fitted above a built-in oven, the hob

and the oven must be connected to the mains separately

for safety reasons and to simplify operations when it is

necessary to pull the oven out for some reason.

Electrical connection

• The electrical safety of this appliance can only be guar-

anteed if the latter is correctly and efficiently earthed,

in compliance with regulations on electrical safety. Al-

ways ensure that this vital safety measure has been

taken. If you have any doubts, call in a qualified techni-

cian to check the electrical system thoroughly.

• The manufacturer denies all responsibility for damage

resulting from a system which has not been earthed

correctly.

• Before powering the appliance, check whether the tech-

nical characteristics featured on the appliance data plate

correspond with those of the mains electrical system.

• Check that the current load of the mains supply and of

the power sockets is suitable for the maximum power

of the appliance, indicated on the appliance data plate.

If in doubt, contact a qualified professional.

Disconnect the appliance from the electricity supply

before all operations.

Connect your hob to the electrical system by means of a

junction box: if the appliance is connected permanently

to the mains, an omnipolar circuit breaker, accessible

if necessary, with a minimum contact opening of 3 mm

should be installed.

Valid only for models with a power supply cable

Some models are supplied with a single-phase power sup-

ply cable, and should consequently only be connected to

the single-phase mains. Observe the wire colours, as indi-

cated in the diagram attached.

Electrical connections Voltage, Frequency Fuses, Sections

FR-BE-AT-DE-GR-ES-IL-

IT-NZ-PT-GP-CH-MA-LU-

IE-FI-SE-IS-GB-NL-DK

230V - 1+N~ 50Hz

CY-MT-AU-NZ-KW

240V - 1+N~ 50Hz

25A *

2,5 mm²

FR-BE-NO

230V - 2 ~ 50Hz

BR=BRUN,BL=BLEU

BR=BRUIN, BL=BLAUW

BR=BRAUN, BL=BLAU

BR=BROWN, BL=BLUE

* Application of the simultaneity coefficient in accordance with

cei 60335-2-6 norm

Valid only for models without a power supply cable

Some models are not fitted with a power supply cable, as

the cable should be sized according to the type of electrical

connection in use (see connection table below). To connect

the cable, proceed as follows:

• Using a screwdriver, prise on the side tabs of the terminal

board cover;

• Pull open the cover of the terminal board.

To install the cable, proceed as follows:

• unscrew the wire clamp screw and the contact screws.

• to make the desired electrical connection (see table),

use the jumpers housed inside the box. Position the

power supply cable wires according to the indications

in the table.

• once the connections have been made, tighten all the

terminal screws fully.

• Fasten the supply cable in place with the clamp and

close the cover of the terminal board.

12345

L1 L2

12345

L1 L2 N

12345

L1 L2 L3

12345

L1 L2 L3 N

12345

L1 L2 N2N1

12 345

12345

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Ariston KBT 6013 ID in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,76 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Ariston KBT 6013 ID Manual

Product: