Manual Ariston FD 51 Ice (page 11 of 58) (English, German, Dutch, French, Italian, Portuguese, Spanish)

454687

Zoom out

Zoom in

1/58

Electromechancial Start/End Cooking Programmer

The Cooking

Programmer

The figure illustrates the

controls for the program-

mer. Knobs 1, 2 and 3

allow you to make all the

necessary settings.

Knob 1

When turned in the

clockwise direction, it al-

lows you to correct the

time setting on the digi-

tal clock (upon installation, after a power failure or when it

runs fast or slow etc.).

Knob 2

When turned in the clockwise direction, it:

– sets the duration of the cooking time (max of 210 min-

utes);

– stops the acoustical signal ( setting);

– sets the oven on manual mode ( setting).

The symbols for the above appear in quadrant 4.

Knob 3

When pressed and turned in either the clockwise or coun-

terclockwise direction, it sets the start of the cooking time

displayed in quadrant 5. When the clock is adjusted, you

must check that the time on the clock is synchronized

with the time shown in quadrant 5.

Manual Operating Mode for the Oven

The oven can be used normally, i.e. without being pro-

grammed. In this case, knob 2 must be turned in the clock-

wise direction until the symbol appears in quadrant 4.

Semiautomatic Operating Mode

The start time is nornal and end cooking time is pro-

grammed:

prepare the food to be cooked; rotate knob 2 in the clock-

wise direction and set the number of minutes for the end

cooking time in quadrant 4; turn the oven knob to the de-

sired temperature. Make sure that the time on the clock is

synchronized with the time shown in quadrant 5.

Automatic Operating Mode

Arrange the food to be cooked; turn knob 2 in the clock-

wise direction, setting the length of the cooking time in

quadrant 4; press and rotate knob 3 in the clockwise di-

rection to set the cooking start time in quadrant 5; turn

the oven knob to the desired temperature setting. At the

end of the cooking time, the "0" in quadrant 4 will be aligned

with the marker; this indicates that the oven is no longer

operating. An acoustical signal will sound to indicate that

the cooking time is over.

To stop the signal, turn knob 2 in the clockwise direction

so that the symbol is aligned with the marker in quad-

rant 4.

Example of programmer setting for the automatic operat-

ing mode for the oven.

End cooking time: 7:00 p.m.

Length of cooking time: 2 hours.

Arrange the food that is to be cooked; turn knob 2 in the

clockwise direction, setting the length of the cooking time

(2 hours) in quadrant 4.; press and rotate knob 3 in the

clockwise direction, setting the end cooking time, 5:00, in

quadrant 5; turn the oven control knob to the temperature

setting desired.

After these settings have been made, the program-

mer will automatically stop and start the oven at 5:00

and 7:00 respectively.

Timer

The programmer can also serve as a timer only if the oven

is not programmed for automatic operating mode and is

not on.

To use the timer feature, turn knob 2 in the clockwise di-

rection to set the time in quadrant 4. The maximum time

setting is 210 minutes. To stop the acoustical signal, turn

knob 2 in the clockwise direction until the symbol is

aligned with the marker in quadrant 4.

Programmed Cooking

Programmed cooking is no different than normal cooking.

The programmer does not control the cooking time set-

ting when you are not present or doing other work. There-

fore, it is best to use the completely automatic mode for

foods which do not require special attention. When pro-

gramming a time greater than 12 hours, it must always

refer to the first 12 hours of the day (e.g. 20:00 must be

understood to mean 8:00 and so forth). Therefore, it is

possible to program cooking 12 hours in advance.

Important

To use the oven manually (without the programmer), the

following is necessary:

1. Upon adjusting the clock, make sure that the time

shown is synchronized with the time shown in

quadrant 5.

2. Turn knob 2 in the clockwise direction so that the

symbol is aligned with the marker in quadrant 4.

Timer Feature

The timer operates by counting down a given period of

time. This feature does not, however, turn the oven on or

off. It merely emits an acoustical alarm when the time has

run out.

How to Set the Timer

Turn the knob in the counter-clockwise direction until the

indicator is set on the length of time desired (using the

inside numbers). The time is clearly visible through the

transparent window on the indicator itself.

The timer will begin to count down immediately.

To turn off the buzzer, or to use only the clock, set the

indicator on the symbol.

I want to fasten inner glas in lid. I unscrewed two screws, hiow do I proceed. Submitted on 10-8-2022 at 15:49
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Ariston FD 51 Ice in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 2,53 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Ariston FD 51 Ice Manual

Product: