Manual Ariston E-Combi One (page 26 of 80) (English)

719960

Zoom out

Zoom in

1/80

26 /

INSTALLATION

Room Thermostat / Remote Clock Connection

To connect a room thermostat, it is necessary to:

1. Open the control panel

2. Loosen the cable clamp using a screwdriver and insert the

wires leading from the room thermostat

3. Connect the wires to the terminals as indicated in the gure

below, removing the link

4. If a remote time clock is to be tted, using a volt free switching

time clock connect the switching wires from the time clock

following points 1 - 3 above

5. If using an external time clock and room thermostat, these

must be connected in series as shown in diagram C,

6. Ensure that they are well connected and not subject to stress

when the control panel is closed

DO NOT CONNECT 240V TO ANY PERIPHERAL CONNECTIONS

Outdoor sensor connection

- Introduce the outdoor sensor wires

- Loosen the cable clamp using a screwdriver and insert the

wires leading from the outdoor sensor one at a time.

- Connect the wires to the terminals as indicated in the gure

below;

- Make sure that they are well connected and that they are

not subject to stress when the control panel lid is opened or

closed;

- Close the ap again, then replace the control panel cover

and the front casing.

- Refer to page 40 for setting the parameters when using the

outdoor sensor.

Note: wheN coNNectiNg the boiler to exterNal coNtrols, do

Not ruN 240V cables aNd cables for switchiNg circuits

(

which are low Voltage) together, use seperate cables to

preVeNt iNduced Voltage oN the low Voltage circuits.

Connector SE on PCB

Outdoor Sensor

Connector TA on PCB

(low voltage switching)

Connector TA on PCB

(low voltage switching)

Connector TA on PCB

(low voltage switching)

Cylinder connection (E-SYSTEM ONE)

The boiler can be connected to a central heating system that

uses two zone valves to allow connection to an indirect storage

cylinder.

There are two wiring diagrams shown, one for the connection

to an Unvented Cylinder and one for connection to an open

vented cylinder.

In both cases the boiler connection is shown as TA1.

When connecting the boiler to an external cylinder do not run

240V cables and the cables for the TA1 together, use separate

cables to prevent induced voltage on the low voltage switching

circuit.

Note: the use of a ‘y’ plaN system is Not possible with the

e-system oNe boiler due to the low Voltage switchiNg of the

appliaNce uNless suitable relay coNtrols are used.

Important!!

Ensure that a balancing valve is tted on the cylinder return

and balanced correctly at commissioning stage.

(see p.25)

Is this the manual for the new Ariston E combi One 24 kw LPG Boiler that does not have a pressure gauge on the front panel ? Submitted on 11-8-2023 at 10:49
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Ariston E-Combi One in the language / languages: English as an attachment in your email.

The manual is 11,88 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ariston E-Combi One

Ariston E-Combi One User Manual - English - 12 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Ariston E-Combi One Manual

Product: