47623
4
Zoom out
Zoom in
Previous page
1/16
Next page
M
ARGHERITA
Margherita - Instructions for installation and use
I
G
L
F
E
H
N
M O
A
B
C
D
effectiveness of the liquid
additives, thus allowing more
resistant stains to be removed.
When you press the stain removal
button, you cannot activate the
pre-wash cycle (I).
Prewash
With this button, you can pre-
wash on all programmes except
the wool programme and the
special programmes (see page 4).
If you use this function, you
cannot use the stain removal
button (H).
On-off
When button L is pressed, the
washing machine is switched on,
when it is not the machine is
switched off.
Turning the appliance off does
not cancel the selected
programme.
The on-off lamp
Lamp M flashes when the
appliance is switched on and
awaiting a programme to be set.
A steady light means the
appliance has accepted the
selected programme.
The door block lamp
The safety lamp indicates that the
washing machine door is locked
to prevent it from being opened
accidentally. To avoid any
damages to lock mechanism, you
must wait for the lamp to
extinguish, before attempting to
open the door which takes
around three minutes.
Programme key
This contains the descriptions of
the wash programmes and the
various functions connected to
the buttons. Pull it outwards to
open it.
Rinse-Hold
This button allows you to
interrupt a programme (on
symbol ) keeping the washing
soaking in water before the spin
cycle. It is a very useful button
in particular because it can be
used for delicates and synthetics.
It is only to be used with wash
programmes for synthetic fabrics,
silk and curtains when it is
impossible for you to take the
washing out immediately. Before
opening the washing machine
door, finish the wash cycle as
follows:
Silk and curtains: press button
F and Margherita 2000 will drain
the water.
Synthetic fabrics: press button F
if you want a spin cycle, or turn
knob A to symbol if you
want the water to be drained.
With "Daily wash" or "Hand
wash", this function is not
enabled.
Rapid wash
This button reduces the length of
the wash programme by about
30%. It cannot be used with
special programmes (see page 4)
or those for wool and silk.
Stain removal (see page7)
Thanks to this command, Mar-
gherita will carry out a more in-
tensive wash that optimises the
Here Im in command
Understanding the control panel
Making the right choice is important. And its easy.
Margherita s knobs are hidden. Just
press them lightly in the middle to
extract them.
Programme selector knob
and programmed start
Use this knob to select the wash
programme.
Turn this knob clockwise only.
To select a programme, you
should turn the knob so that the
symbol/number of the desired
programme is in line with the
pointer on the glass O.
Now press on/off button L
(position ON), pilot lamp M will
start flashing.
After 5", the setting will be
accepted, pilot lamp M will stop
flashing (staying lit) and the wash
cycle will begin.
Should you wish to interrupt the
programme in progress or set a
new one, select one of the
symbols
(Stop/Reset) and wait
5" : when the cancellation has
been accepted, pilot lamp M
flashes, and you can then turn the
appliance off.
Delay timer
You can use this knob to delay
the appliance's operation.
Select one of the four delay time
positions, press the on/off button
L (position ON) and wait 5". The
setting has now been accepted
(pilot lamp M stays lit) and you
can select the programme you
desire.
Pilot lamp M has a particular
flashing motion (2" on and 4"
off) to indicate that a delayed
start has been set.
During this phase, you can open
the appliance door and change
the washing load, should you
wish to do so.
After the wash cycle has been set
and accepted by the washing
machine, turning the knob will
have no effect (except for when
it is on position
Stop/Reset).
Temperature control knob
It is used to set the wash tempe-
rature in the recommended
programme table on pag. 4. It also
allows you to reduce the tempe-
rature recommended for the
selected programme, and even to
set a cold wash cycle ( ).
Spin exclusion knob
It is used to exclude the spin
cycle (by choosing symbol
) or
to reduce the spin speed of the
selected programme. The
maximum speed for the four
types of fabric are:
Fabric Speed
Cotton 1400 rpm
Synthetics 800 rpm
Wool 600 rpm
Silk no
Note: distribution phase will be
carried out at low speed.
Detergent dispenser
It is divided into three
compartments:
1. Detergent for pre-wash;
2. Detergent for the main cycle
wash;
3. Fabric conditioner.
The washing machine is
equipped with an extra
compartment 4 (provided as an
accessory) for the bleach, to be
inserted in compartment 1.
The detergent dispenser with
the additional bleach
compartment is here.
3
M
A
X
1
2
4
3
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ariston A1435 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ariston A1435 in the language / languages: English as an attachment in your email.

The manual is 1,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info