290006
6
Zoom out
Zoom in
Previous page
1/18
Next page
Top panel
Powering Up
Battery Installation
1. Slide the compartment cover at the bottom of your camera. See Figure 1.
2. Install 3-AAA alkaline batteries into the battery compartment. See Figure 2.
3. Make sure the battery polarities are oriented exactly as shown. See Figure 2.
4. Close battery compartment cover.
Figure 1 Figure 2
CAUTION - To avoid battery leakage
Non-rechargeable batteries are not to be recharged
Be sure to insert batteries in correct orientation
Remove batteries from the camera before extended storage
Always remove old or dead batteries from the camera
Do not short-circuit the power supply terminals
Check that the contact surfaces are clean and bright before installing batteries
Battery Power Levels
If at anytime the frame counter information begins to flash in the LCD panel, the battery level is
low. Download your photos to the computer and replace the batteries immediately.
Turning camera on / off
Press Mode button to power on the camera. Two short beeps will sound.
(High Resolution) will
appear momentarily before
(frame counter) is shown on the LCD panel, indicating that a maximum
of 20 photos can be taken with high resolution.
To power off the camera, press Mode button repeatedly until "oF" displays on the LCD panel. Then
press Shutter button.
Auto Off
The camera will automatically turn off in 30 seconds if no operation has been performed.
Taking Pictures
Resolution
The camera is defaulted to High Resolution (CIF) mode
.
To select low resolution (QCIF):
1. Press Mode button repeatedly until
is shown on the LCD panel.
2. Press Shutter button to confirm your selection and "80" will appear on the LCD panel, indicating
that a maximum of 80 photos can be taken with low resolution.
NOTE: After taking a few photos of low resolution, if you want to switch back to high resolution: (1)
Press Mode button until
appears on the LCD panel (2) Press Shutter button to confirm your
selection and the remaining number of photos that can be taken will be shown on the LCD panel.
Selecting AC frequency
This camera is set to your country's AC mains frequency (e.g. 60Hz for US, 50Hz for Europe). If you
take photos under an electric light source in another country with a different frequency, you have to set
the frequency to match the AC mains frequency of the country you are in. Otherwise horizontal, black
stripes will be found on the taken photos due to incorrect mains frequency. There will be no problems
when taking photos under sunlight.
To change the frequency:
1. Press Mode button repeatedly until "60 (Hz)" or "50 (Hz)" is shown on the LCD panel.
2. Press Shutter button to change from "60 (Hz)" to "50 (Hz)" (or from "50 (Hz)" to "60 (Hz)" to match
that country's AC mains frequency.
For example, if the preset for your camera is 60 (Hz), you will see 50 (Hz) on the LCD panel when
you press Mode button repeatedly. To change to 50 (Hz), press Shutter button once.
Taking a photo
You may choose to hold camera as shown in Figure 1 or Figure 2 when taking photos.
Figure 1 Figure 2
1. Look through the viewfinder.
NOTE: The focus is set to work best when taking photos of an object that is at least 2 feet away
from the camera.
2. Press Shutter button.
You will hear a "beep" and the frame counter will count down 1 frame, indicating that an image has
been taken.
5
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Argus dc 1510 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Argus dc 1510 in the language / languages: English as an attachment in your email.

The manual is 3,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Argus dc 1510

Argus dc 1510 User Manual - Spanish - 17 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info