477714
25
Zoom out
Zoom in
Previous page
1/146
Next page
ARGUS
A
RGUS 125 25
Initialization phase:
- Intialization on a BRI or U-Interface access
Next the ARGUS will setup Layer 1. While it is setting up Layer 1, the “L1 Sync” LED above
the display will blink. If the ARGUS cannot setup Layer 1, it will display the message “No
Net”. When the ARGUS is operated on a U-interface access, it can take up to 2.5 minutes
to activate Layer 1. As soon as Layer 1 is successfully setup, “L1 Sync” LED will light
continuously.
Once Layer 2 has been setup, the “L2 Rx/Tx” LED will light.
If both modes (P-P / P-MP) are found when Layer 2 on the D-channel is checked,
the mode must be selected manually (see page 33).
If everything has been correctly detected, the ARGUS will display the type and mode of
access found. Additionally, a qualitative assessment of the level will be displayed.
The ARGUS will automatically determine the protocol (in both TE and NT mode) or use the
protocol set manually (see page 120 Protocol). On a bilingual access, the ARGUS will use
the DSS1 protocol.
The “L3 Conn” LED will light after the ARGUS has setup Layer 3. At the same time the
ARGUS will start the B-channel test. The results will be displayed on the ARGUS. If an
error occurs in the B-channel test (e.g. access is not plugged-in), the ARGUS will -
depending on the class of error - either repeat the initialization or show an error message
(see page 145). The ARGUS will then idle in the Status display.
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Argus 125 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Argus 125 in the language / languages: English as an attachment in your email.

The manual is 0,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info