689093
29
Zoom out
Zoom in
Previous page
1/32
Next page
V 03/17
61
1. Remove the cover of the terminal block
on the right side of the outdoor unit. (one
screw)
2. Connect the wires to the unit as shown
in the figure, make sure that each cable
is properly connected to the terminal
boards of the two units.
3. Reassemble the cover of the terminal
Insert a magneto thermic switch
with sufficient power and
observe the following table:
Power circuit
breaker
10A
To protect the unit against short
circuits, mount on the power line
amagneto thermalomni polar
switch (IG) curve C 250V with a
minimum contact opening of
3mm.
Wrong connection of cable may
cause malfunctions of the
electrical components.Once fixed
the cables, make sure that the
lines between the links and the
fixing point are separated by
some space
The connection pipes and
connection cables of units A and
unit B must correspond to each
other.
The device must be installed in
accordance with national
regulations of wiring.
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Argo X3MI 56 SH at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Argo X3MI 56 SH in the language / languages: English as an attachment in your email.

The manual is 3,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info