689096
22
Zoom out
Zoom in
Previous page
1/32
Next page
V 03/17
54
Indoor unit installation
Decide where to install the unit based on room design, architectural limitations and customer
requirements. Check that in the selected location the unit can be accessed for servicing and
cleaning the filters. To install, use the installation plate as a template to identify the exact position
for the wall plugs and through-hole in the wall. The plastic casing has stoppers which if necessary
can be removed to route the refrigerant lines and cables. When operating in cool or dry mode, the
moisture in the air condenses on the coil of the indoor unit, collects in the basin and drains out
through the special rubber hose. The hose must be connected to a pipe with a suitable gradient,
ensuring no unnecessary bends are created. Do not run siphons and do not immerse in water.
Step two: mount the wall-installation plate
1. Position the installation plate on the wall. Use a level to position it horizontally and mark the
holes for the bolts on the wall.
2. Drill the holes for the screws in the wall with a hammer drill (the drill bit must match the plastic
wall plug). Then insert the wall plugs into the holes.
3. Secure the plate to the wall with the self-tapping screws (ST4.2X25TA). Check it is securely
attached by pulling on the bracket. If a plastic wall plug is loose, drill another hole nearby with the
hammer drill.
Step three: drill the hole for the piping
Select the position for the piping hole according to the direction of the outlet pipe. The piping hole
must be slightly lower than the wall-installation frame, as shown below.
Drill a piping hole of diameter
55 or 70 at the chosen location for the outlet pipe. To allow for
proper drainage, the piping hole in the wall must slant slightly downwards to the outdoor side, with
a gradient of 5 – 10°.
Piping hole Model
Ø 55 Cooling capacity < 6000 W
N.B.:
Take the necessary safety measures when
drilling the hole and do not allow dust to
enter.
The plastic wall plugs are not supplied but
must be purchased on site.
Interno
5-10
Esterno
Φ55
Indoors
Outdoors
Step four: outlet pipe
The pipe can be brought out in various different
directions: right, rear right, left or rear left.
Once you have selected the direction of the
outlet (left or right), drill the corresponding
hole at the bottom.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Argo X3I 52HL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Argo X3I 52HL in the language / languages: English as an attachment in your email.

The manual is 3,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info