805067
9
Zoom out
Zoom in
Previous page
1/21
Next page
31V 05/23
HOW TO USE THE APPLIANCE
OPERATING MODES
This appliance can be used for Cooling, Dehumidication and Ventilation. Before using the appliance, leave it in an
upright position for at least two hours.
Plug the power cord into an appropriate power outlet (220-240~V). Insert the batteries into the remote controller,
observing the polarities. Select the desired operating mode from the remote controller.
The air conditioner is equipped with a protection system which causes the unit to activate in Cooling and Dehumidication
mode only after an interval of approximately 3 minutes from the selection. Even when passing from one mode to
another, the fan continues to operate, but the compressor stops to restart after 3 minutes. This start delay protects the
compressor from overload.
THE DRAINAGE TUBE MUST BE CONNECTED to the appliance AT ALL TIMES: the only exception is when the
appliance is used in dehumidication mode only, in which case the appliance should be left to discharge directly
into the room for maximum efciency (see the “Dehumidication Mode” paragraph).
Periodically clean the easily removable air lter located on the side of the product to keep the air conditioning efcient.
1. COOLING MODE (COOL)
Press the MODE button to select Cooling. The LED on the control panel lights up.
The temperature adjustment range goes from 16 °C to 32 °C with 1 °C steps.
In this mode, every time the unit is switched off by pressing the POWER button the appliance stores the set
temperature and when it is switched on again it will keep the setting.
In cooling mode, the fan speed is high by default.
In this mode it is possible to adjust the ventilation speed (Speed), set the Timer and activate the Sleep function
by holding down the Speed button for 3 seconds.
For quieter operation, reduce speed to low.
2. DEHUMIDIFICATION MODE (DRY)
Press the MODE button to select the Dehumidication mode. The LED on the control panel lights up.
The temperature is controlled by the electronic board and cannot be adjusted.
In this mode, each time the POWER button is pressed the unit switches off, the appliance saves the settings
and retains them when it is switched on again.
The humidity % adjustment range is 35-80%, in dehumidication mode it is however not possible to adjust
the humidity %.
The fan speed cannot be adjusted.
NOTE: the air conditioner does not cool the room when operating as a dehumidier. When the appliance is
used as a dehumidier, the exible pipe must not be connected. For maximum dehumidication efciency, leave
the rear discharge attachment free to discharge directly into the environment. The dehumidication mode is
recommended during autumn and winter. If used during summer, it is best to leave the exible pipe attached so
that the hot air is discharged towards the outside rather than into the room. During dehumidication, continuous
drainage should be implemented (see the next chapter, “HOW TO ELIMINATE CONDENSATE”).
Cooling, Fan Dehumidifying
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Argo Nikko at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Argo Nikko in the language / languages: English as an attachment in your email.

The manual is 10.21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Argo Nikko

Argo Nikko User Manual - German - 22 pages

Argo Nikko User Manual - French - 22 pages

Argo Nikko User Manual - Italian - 22 pages

Argo Nikko User Manual - Spanish - 22 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info