805018
9
Zoom out
Zoom in
Previous page
1/14
Next page
24
V 02/22
Auto mode: When the humidity in the room is 3% higher than the set one, the ventilation and the compressor start to
work after 3 minutes. On the other hand, when the humidity in the room is 3% lower than the set one, the compressor
stops while the ventilation continues for a short period of time.
In Auto mode it is possible to adjust the ventilation and humidity level.
Continuous mode: The unit works continuously, but it is not possible to adjust the humidity level and ventilation.
Sleep mode: Press the Mode button on the control panel to activate this function, the symbol lights up on the display. If
no selections are made on the control panel within 10 seconds, the display turns off and the fan speed changes from
high to low. To reactivate the lighting, press any button on the control panel. Press the Mode button again to deactivate
this function.
In sleep mode, the fan speed cannot be adjusted but the humidity level can be adjusted.
3. HUM BUTTON (HUMIDITY): press this button to adjust the desired humidity in the room (from 30 to 80%) in steps of
5% By keeping this button pressed for a long time, the humidity level in the room is shown on the display.
4. TIMER BUTTON: allows you to program switching on (if the unit is off) or switching off (if the unit is on) from 0 to 24
hours. Each time the button is pressed, the adjustment interval corresponds to 1 hour, and it is possible to view the time
set on the display, the symbol on the display remains lit during the set time interval. It is always possible to view the set
time by pressing the Timer button, then the display will return to showing the humidity level detected in the environment.
To deactivate the Timer, “00” must appear on the display (flashes 4 times), and the Timer symbol on the display will turn
off.
5. SPEED BUTTON (VENTILATION SPEED): It is possible to adjust the ventilation speed only in Auto mode. Press this
button to adjust the speed from high to low, the corresponding symbols will light up on the display according to the
selection made.
6. LOCK BUTTON: Long press of this button activates the control panel lock function, the corresponding symbol on the
display lights up, and it is no longer possible to make selections on the control panel. Long press this button again to
deactivate this function, the symbol goes off on the display.
When the appliance is switched off, the child lock function is automatically deactivated.
MEMORY FUNCTION: the dehumidifier starts up again after a power failure keeping last settings.
COLOR LED
On the front panel of the dehumidifier there is a LED that shows different colors based on the humidity level detected in the
room:
Blue = Ambient humidity below 45%
Green = Ambient humidity between 45% and 65%
Red = Ambient humidity above 65%
If E0, E2, CL, CH, LO, HI appear on the display on the control panel, the color of the LED will be red.
(for error codes refer to the troubleshooting section).
CLEANING AND MAINTENANCE
MAINTENANCE OF THE HUMIDIFIER’S EXTERIOR SURFACE
Warning
Always pull the dehumidifier's plug out of the power socket before cleaning it, to prevent electric
shock and malfunction.
Warning
Do not wet the appliance or immerse it in water, otherwise electric shocks may occur.
Use a damp and soft cloth to clean the exterior surface of the dehumidifier.
Do not use solvents, petrol, xylene, talcum powder or brushes to clean the unit: these may damage
the surface or colour of the casing.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Argo LILIUM ART 11 - 13 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Argo LILIUM ART 11 - 13 in the language / languages: English as an attachment in your email.

The manual is 0.86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Argo LILIUM ART 11 - 13

Argo LILIUM ART 11 - 13 User Manual - German - 15 pages

Argo LILIUM ART 11 - 13 User Manual - French - 16 pages

Argo LILIUM ART 11 - 13 User Manual - Italian - 15 pages

Argo LILIUM ART 11 - 13 User Manual - Portuguese - 15 pages

Argo LILIUM ART 11 - 13 User Manual - Spanish - 14 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info