665484
19
Zoom out
Zoom in
Previous page
1/25
Next page
19
GB
6.3.5 - SHUTDOWN FORCED CIRCULATOR OPERATION
Press and hold the button for 5 seconds.
The circulator stops.
The circulator indicator light and the “H
2
O” flow rate light do out.
6.4 - OPERATION
Installation power is ON.
Start the system in the desired operating mode using the control box button (consult the system control manual and the
control box user's guide).
6.3.4 - CIRCULATOR SPEED SETTING
It is possible to select between 6 circulator curves, in two control modes:
Three proportional pressure curves (PP).
Three constant pressure curves (CP).
PP1 PP2 PP3
CP1CP2CP3
Factory setting : Constant pressure curve CP2
To change the setting:
Push the button for two seconds:
Pump goes to setting mode - LEDs start flashing.
Every time you push the button, the speed setting changes:
LEDs 1-2-3 flash in sequence (see the figure).
Fast flashing: proportional pressure (PP)
Slow flashing: constant pressure (CP)
After ten seconds without pushing the button:
The speed is set.
Pump returns to operating mode.
At this point LEDs remain on according to the setting and pump will run with the selected curve and mode.
I
II
III
I
II
III
I
II
III
I
II
III
I
II
III
I
II
III
PP1
PP2
PP3
CP1
CP2
CP3
FAST FLASHING
SLOW FLASHING
FACTORY
SETTING
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Argo Hydrokit at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Argo Hydrokit in the language / languages: English as an attachment in your email.

The manual is 2,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Argo Hydrokit

Argo Hydrokit User Manual - English - 14 pages

Argo Hydrokit Installation Guide - German - 25 pages

Argo Hydrokit User Manual - German - 14 pages

Argo Hydrokit Installation Guide - French - 25 pages

Argo Hydrokit User Manual - French - 14 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info