805092
19
Zoom out
Zoom in
Previous page
1/30
Next page
50V 11/22
The minimum clearance between the air conditioner and the combustibles is 1.5 m.
The interconnection cord connect the indoor and outdoor units. You must rst choose the right cable size before
preparing it for connection.
Cable Types:
Outdoor Power Cable: H07RN-F or H05RN-F;
Interconnection cord: H07RN-F or H05RN-F;
Minimum Cross-Sectional Area of Power cable and interconnection
cord:
The size of the interconnection cord, power cable, fuse, and
switch needed is determined by the maximum current of the unit.
The maximum current is indicated on the nameplate located on the
side panel of the unit. Refer to this nameplate to choose the right
cable, fuse, or switch.
Note: core number of cable refer to the detailed wiring diagram
adhered on the unit which you purchased.
INSTALLATION WARNINGS
WARNING: Make sure that the power supply is disconnected before carrying out any work on the unit.
WARNING: Wear appropriate personal protective equipment before carrying out any work on the unit.
WARNING: The appliance must be reinstalled in accordance with national system regulations.
WARNING: Wiring and installation must only be performed by a qualied technician trained to install, modify,n
extend and service the unit and perform safety and functionality tests.
WARNING: Install a device, master switch or electric plug that will allow all the power from the appliance to be
switched off.
The following information is essential for correct unit installation. However, the installer should use his or her
experience to install the unit according to specic requirements.
Do not install the unit in locations where there are ammable gases or acid or alkaline substances that may
irreparably damage the copper-aluminium heat exchangers or internal plastic components.
Do not install the unit in ofces or kitchens where oil vapours mixed with treated air may settle on the exchange
coils, reducing performance, or on the unit’s internal parts, damaging the plastic components.
ATTENTION: For the connection between the units, use only annealed and deoxidized copper pipe for
conditioning and refrigeration and insulated with expanded polyethylene of min. 8 mm.
ELECTRICAL CONNECTION REQUIREMENTS
Electrical safety standards must be met when installing the unit.
Use a power supply circuit and circuit breaker that comply with local safety regulations.
Make sure that the power supply matches the requirements of the air conditioner. An unstable power supply or
incorrect wiring may result in a fault. Install suitable power cables before switching on the air conditioner.
Correctly connect the live, neutral and earth wires to the power outlet.
Disconnect the power supply before carrying out any work on the electrical circuit or carrying out any safety work.
For models with a plug, make sure the plug is easily accessible after installation.
Do not connect the power before installation is complete.
Do not use the appliance if the power cable or plug are damaged. If the power cable is damaged it must be
replaced by the manufacturer, retailer or other qualied person to avoid a hazard.
Since the temperature of the cooling circuit is high, keep the interconnecting cable away from the copper pipe.
The unit must be installed in accordance with national wiring regulations.
Installation must only be performed by trained individuals in accordance with regulations.
The unit is charged with a slightly inammable refrigerant, R32. Improper handling of this gas may
expose people and materials to serious damage. More details on this refrigerant are given at the
beginning of this manual.
REQUIREMENTS FOR OPERATIONS AT HEIGHT
When carrying out installation at 2 m or higher above the base level, safety belts must be worn and ropes of
Rated current of
appliance (A) Nominal corss-
sectional area (mm2)
> 3 e 6 0.75
> 6 e 10 1
> 10 e 16 1.5
> 16 e 25 2.5
> 25 e 32 4
> 32 e 40 6
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Argo Greenstyle Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Argo Greenstyle Plus in the language / languages: English as an attachment in your email.

The manual is 3.07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Argo Greenstyle Plus

Argo Greenstyle Plus User Manual - Italian - 31 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info