805017
6
Zoom out
Zoom in
Previous page
1/17
Next page
24V 04/23
APPLIANCE START-UP
Place the product on a at and stable heat-resistant surface, at least 1 metre away from ammable or heat-sensitive
materials and 50 cm away from walls or other obstructions.
Make sure the water tank is in the correct position.
Connect the power cord to a suitable electric socket (220-240V~).
Turn the appliance on with POWER on the control panel. The unit emits a sound signal and is in standby, the colored
LED on the front panel lights up. The display shows the humidity% detected in the room, therefore set a humidity % lower
than at least 3% compared to that in the room to make the dehumidier work.
The dehumidier is designed to operate at ambient temperatures from + 5°C to + 35°C.
If it is operated at low temperatures, ice may form on the evaporator, degrading its operation.
When this happens, the dehumidier goes into defrost mode. The compressor stops, but the fan continues running.
The defrosting operation may start up and operate for some minutes; during the defrosting operation, the dehumidication
function may intermit: please don’t turn off the switch or pull out the power plug of the dehumidier.
We recommend not using the dehumidier in room temperatures lower than 5°C.
Do not remove the tank when the unit is in operation.
If you wish to make continuous draining of condensate, follow the instructions in the dedicated paragraph.
OPERATING PRECAUTIONS
The dehumidier starts only if the humidity level in the room is higher than 3% the set one.
The dehumidier will continue to operate until the set humidity level is reached, except for any interruptions due to
lling the tank.
When the water tank is full, the compressor stops running immediately and dehumidication stops; the fan stops after
3 minutes. Empty the tank and reposition it: after carrying out these operations, the unit will start operating again.
ATTENTION:
After each interruption of operation, at least 3 minutes must elapse before the dehumidier restarts: this startup delay
protects the compressor from damage.
If, on the other hand, the humidity% set is higher than that present in the room, the dehumidier will not start.
If, after following the instructions for starting the dehumidier, the dehumidier does not start and the (POWER) symbol
does not light up, or the dehumidier stops without reason, check that the condition of the plug and the power cord
are good. Once this is done, wait 10 minutes and then restart the dehumidier.
If, even after 10 minutes, the dehumidier does not start, or if the cable or the plug are damaged, switch off the
dehumidier and contact a technical assistance center.
WARNING:
When the dehumidier is running, the compressor produces heat and the appliance emits warm air into the room.
The room temperature will therefore tend to increase. This is completely normal.
SWITCHING OFF THE DEHUMIDIFIER
To turn the dehumidier off press the POWER button. This shuts off power to the unit.
Unplug the appliance if you do not intend to use it for some time.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Argo DRY PURY EVO 11-13 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Argo DRY PURY EVO 11-13 in the language / languages: English as an attachment in your email.

The manual is 9.31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Argo DRY PURY EVO 11-13

Argo DRY PURY EVO 11-13 User Manual - German - 18 pages

Argo DRY PURY EVO 11-13 User Manual - French - 18 pages

Argo DRY PURY EVO 11-13 User Manual - Italian - 18 pages

Argo DRY PURY EVO 11-13 User Manual - Portuguese - 18 pages

Argo DRY PURY EVO 11-13 User Manual - Spanish - 106 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info